Sharp CDBA3000 User Manual
CD-BA3000H
OPERATION MANUAL
settings, and tuner and CD presets).
Reset the microcomputer under the following con-
ditions:
● To erase all of the stored memory contents (clock and timer
RESETTING THE MICROCOMPUTER
Press the ON/STAND-BY button to enter the stand-by mode.2Whilst pressing down the button and the X-BASS/
● If the display is not correct.
● If the operation is not correct.
1
DEMO button, hold down the ON/STAND-BY button for at
least 1 second.
● “CLEAR AL ” will appear.
memory including clock and timer settings, and tuner and
CD presets.
Caution:
● The operation explained above will erase all data stored in
Remote control
if the operation becomes erratic.
■
Notes concerning use:
● Replace the batteries if the operating distance is reduced or
● Periodically clean the transmitter LED on the remote con-
PREPARATION FOR USE
trol and the sensor on the main unit with a soft cloth.
interfere with operation. Change the lighting or the direction
of the unit.
shock, and vibrations.
● Exposing the sensor on the main unit to strong light may
● K eep the remote control away from moisture, excessive heat,
0.2 m - 6 m
(8" - 20’)
Press the ON/STAND-BY button to enter the stand-by mode.2Press the CLOCK button.3Within 5 seconds, press the MEMORY/SET button.4Press the TUNING/TIME ( or ) button to select the time
In this example, the clock is set for the 24-hour (0:00) system.
1
(Main unit operation)
SETTING THE CLOCK
display mode.
(0:00 - 23:59)
“0:00” →The 24-hour display will appear.
“AM 0:00” →The 12-hour display will appear.
(AM 0:00 - PM 11:59)
(AM 12:00 - PM 11:59)
stalled or it has been reset.
“AM 12:00” →The 12-hour display will appear.
● Note that this can only be set when the unit is first in-
Press the MEMORY/SET button.6Press the TUNING/TIME ( or ) button to adjust the hour .
5
vance the time by 1 hour. Hold it down to advance con-
tinuously.
● Press the TUNING/TIME ( or ) button once to ad-
● When the 12-hour display is selected, “AM” will change
automatically to “PM”.
Press the MEMORY/SET button.8Press the TUNING/TIME ( or ) button to adjust the min-
7
vance the time by 1 minute. Hold it down to change the
utes.
● Press the TUNING/TIME ( or ) button once to ad-
– 6 –
time in 5 minute intervals.
● The hour setting will not advance even if minutes advance
from “59” to “00”.
Press the MEMORY/SET button.
9
(Seconds are not displayed.)
● The clock starts operating from “0” second.
And then the clock display will disappear after a few sec-
onds.
To see the time display:
Press the CLOCK button.
CLOCK button when the AC power supply is restored after
● The time display will appear for about 5 seconds.
Note:
● The clock display will flash on and off at the push of the
a power failure occurs or after the AC power lead is discon-
nected.
clock time.
If this happens, follow the procedure below to change the
To change the clock time:
1 Press the CLOCK button.
Within 5 seconds, press the MEMORY/SET button. 3Perform steps 6 - 9 above.
2
To change the time display mode:
1 Perform steps 1 - 2 in the section “RESETTING THE MI-
CROCOMPUTER”. 2Perform steps 1 - 9 above.
Loading...