Dear Customer
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance. This product
complies with all binding CE labelling
directives.
Familiarisation
1. Feeder opening stopper
2. Blender jug
3. Motor housing
4. Push switch
5. Control switch
6. Safety switch
7. Feeder opening
8. Lid
9. Contact pin
10. Power cord with plug
11. Rating label
12. Blade
13. Drive shaft coupling
Important safety instructions
● Before the appliance is used, the main
body as well as any attachments should
be checked thoroughly for any defects. If
the appliance, for instance, has been
dropped onto a hard surface, it must no
longer be used: even invisible damage
may have adverse effects on the
operational safety of the appliance.
● Do not leave the appliance unattended
while in use and keep children away.
● This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
● Children should be supervised to ensure
that they do not play with the appliance.
● Caution: the blade is extremely sharp. To
prevent injuries, take special care when
cleaning the appliance.
● Do not touch any moving parts during
operation - this can be extremely
dangerous.
● Do not allow the appliance or its power
cord to touch hot surfaces or to come
into contact with any heat sources.
● Always switch the appliance off and
remove the plug from the wall socket,
- before opening the lid,
- before removing or fitting the blender
jug,
- before cleaning,
- in case of any malfunction during use,
- after use.
● When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● This appliance is only intended for
domestic use and not for commercial
applications.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel. If repairs are
needed, please send the appliance to one
of our customer service departments.
The address can be found in the
appendix to this manual.
Before using for the first time
Before the appliance is used for the first
time, the blender jug and the lid should be
thoroughly cleaned as described in the
section General Care and Cleaning.
Switch settings
The following settings can be selected:
P The appliance remains switched on as
4
Blender