Seco-Larm SK-910R4Q, SK-919TP4J-NUQ Specsheet

Copyright 2013 © SECO-LARM U S A, Inc All rights reserved

PiSK-910R4Q.docx

16842 Millikan Ave, Irvine, CA 92606

4-Channel RF Transmitters and Receiver

SK-919TP4J-NUQ 4-Button Pre-Coded Transmitter
SK-917TP4J-NU

• Range: Up to 500ft (152m)*, 315MHz

SK-910R4Q Specifications:

Operating frequency

315MHz

15 Transmitter button codes per

channel, 60 total

Operating voltage

11~24 VAC/VDC

Operating
current

Standby

8mA@12VDC

Active

30mA@12VDC

Relay contact rating

Form C 10A@24VDC/120VAC

Screw terminals: Power (+,-),

1 relay per channel (NO/NC/COM)

Dimensions

55/16”x315/16”x11/8” (135x100x28 mm)

SK-919TP4H-NUQ 4-Button Handheld Transmitter

• Range: Up to 500ft (152m)*, 315MHz

SK-910R4Q 4-Channel Receiver

• Five programmable relay output modes:

SK-919TP4J-NUQ

SK-919TP4H-NUQ

SK-910R4Q

*Actual range will vary greatly depending on the ins tallation and operatin g environment

Also Available from SECO-LARM®:

SK-91ERSD

Increase range up to 1,000ft
Range Antenna

• LED Transmission indicator

• Attractive slimline design

• Over 68 billion possible codes

• Includes 12VDC alkaline battery

• Compatible with all 315MHz SECO-LARM receivers

• SK-917TP4J-NU: Code changes every time transmitter button is pressed

4-Button CODEBUMP™ Transmitter

• Attractive slimline design

• Over 68 billion possible codes

• Includes two 3VDC lithium batteries

• Compatible with all 315MHz SECO-LARM receivers

• Visor clip and belt clip included. Belt-clip holster and wall-mount

bracket also available (model #: SK-9HBC)

• Low battery indicator – LED flashes when battery drops below 2VDC

- Timed

- Momentary (1, 2, 3, 4, 5, 10, 30, or 60 sec)

- Toggle (ON/OFF)

- Latch

- Validity

• 11~24 VAC/VDC Operation

• Range: Up to 500ft (152m)*, 315MHz

• Independently programmable outputs

• Controls garage doors, gates, house lights, alarm panels or other

devices via remote

• Four LEDs indicate RF reception, learn mode entered,
transmitter learned, memory cleared, and relay output mode

• Pushbutton programming, no need to cut jumpers

• Up to 15 transmitter button codes per channel can be learned

• Compatible with all 315MHz SECO-LARM transmitters

Tel: [phone] • Fax: [phone]
[e-mail] • www.seco-larm.com

(304m)* with the Extended

Memory capacity

Connectors

The SECO-LARM policy is one of continual developme nt For tha t reason, SECO-LARM reserves the right to

change prices and specifications without not ice SECO-LARM is no t res po ns ible fo r misprints