Seco-Larm SD-H412 User Manual

r

Features:

Electric Transfer Hinge

SD-H412

Manual

The ENFORCER SD-H412 Electric Transfer
Hinge provides a vandal-resistant method for
protecting and concealing wires between a
hollow door and door frame. It is suitable for
low-voltage, low-current applications such as
electric door strikes, locksets, and deadbolts
or other monitoring or exit devices and is
easily installed, replacing the center hinge.

Parts List:

1x Hinge 8x Wood Screws
8x Metal Screws 1x Manual
1x Mounting Template

Overview:

Type

Operating voltage 12~24 VAC/VDC

Current 28AWG 0.5@24VAC/VDC

Wires

Operating
temperature
Dimensions 41/2"x41/2"x1/8"
Weight 16-oz (454g)

5-knuckle, 4-wire transfer hinge

with concealed wiring

4x 28AWG

(red, black, white, green)

-4°~185° F (-20°~85°C)

Fig. 1

Electric Transfe

Hinge installation

Dimensions:

41/2" (114 mm)

location

1

/2"

4

(114 mm)

ENFORCER Electric Transfer Hinge

(

A

(1) y

Installation:

1. Using the included template, prepare the door frame and door for the hinge and drill

5

/8" (16mm) wiring holes in the door and frame to accommodate the wiring. Take care
to ensure that there are no burrs or sharp edges around the holes. Note: the Electric
Transfer Hinge is not designed to bear the load of the door, and thus should be
installed between the upper and lower load-bearing hinges (see Fig. 1).

2. Make the wiring connections.

3. After the wires are connected, gently feed the wires through the wiring holes in the
frame, taking care not to scratch the wire insulation or crimp any wires. Install the
hinge to the frame without tightening the mounting screws completely.

4. Repeat with the wires through the door’s wiring holes and install the hinge to the door.
Test by closing and opening the door, and if there are no problems, then tighten the
mounting screws on both the door and frame.

Important Notes:

1. The ENFORCER Electric Transfer Hinge is not meant to be load-bearing, and should
be installed in place of a center hinge.

2. Only one Electric Transfer Hinge can be installed in a single door.

3. Do not pick up the hinge by grabbing the wires and do not pull the wires as this may
damage them. Such resulting damage is not covered by the warranty.

4. Take care when feeding the wires through the door and frame wiring holes, make
sure not to crimp or damage the insulation.

5. Disassembling the hinge will void the warranty.

WARRANTY:

service for one

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints.
are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All
rights reserved.

SECO-LARM

This SECO-LARM product is warranted against defects in material and workmanship while used in normal

ear from the date of sale to the original customer.

®

U.S.A., Inc.

16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Phone:

949) 261-2999 | [phone] Email: [e-mail]

MI_SD-H412_191001.docx

2 SECO-LARM U.S.A., Inc.

ll trademarks

PICGN3