Schlage FE576 Installation Instructions
*24046435*
24046435
Keypad Entry with Built-in Alarm
Installation Instructions
Model FE576
Exterior
Keypad
Tools Needed
• Phillips screwdriver
Optional Tools
• Tape Measure
• Pencil
• Flathead Screwdriver
• Wood Block
• Hammer
Alarm
Interior
Optional Latch
Faceplate
Batteries
Pin Wrench
Important Notes
• DO NOT use a power drill for installation!
• Use a screwdriver to remove product from packaging.
• Install and test lock with door open to avoid being locked out.
1
Check Dimensions.
If door dimensions do not match, go to www.schlage.com for
drilling instructions.
2C\,” (60 mm)
OR
2C\v” (70 mm)
2Z\,” (53 mm)
Hole
2
Install strike onto door jamb.
Actual Size (2)
3
Change faceplate, if necessary.
Choose the drawing that matches your door edge. If the hole
has no mortise, change to the circular faceplate.
5
Install 9V battery into Keypad Exterior.
No change necessary.
4
Install Latch.
Make sure latch angle faces door jamb.
Interior
6
Install AAA batteries into Alarm Interior.
7
Install Keypad Exterior.
Angle
Actual Size (2)
Angle
Bar should slide
smoothly through
hole in latch. If
not, check door
dimensions.
Wood Block (not
included)
8
If needed, switch levers.
Correct
No change necessary.
Incorrect
a. For the Keypad Exterior, insert the pin
wrench into the hole in the lever. Push
in and hold.
b. Pull the lever off.
c. Repeat steps a and b to remove the lever from
the Alarm Interior.
Note location
of lever catch.
d. Rotate the chassis so lever catch is on the
other side. Then use the lever from the Keypad
Exterior to reassemble the Alarm Interior.
Lever catch now on
other side of chassis.
Lever from Keypad
Exterior
e. Put the lever from the Alarm Interior on the
Keypad Exterior.
Lever from Alarm
Interior
Loading...