Schlage FE575 Installation Manual
*23780026*
23780026
Keypad Lock
Model FE575
Tools Needed
• Phillips screwdriver
• Tape Measure
• Pencil
Additional Parts
Pin Wrench
Optional Latch
Faceplate
Optional
• Flathead
Screwdriver
• Wood Block
• Hammer
Key
Keypad
Latch
Installation Instructions
Inside Lever
Lever Screws (2)
Latch/Strike
Screws (4)
Strike
Prepare for Installation
IMPORTANT NOTES
• DO NOT use a power drill for installation!
• Use a screwdriver to remove product from packaging.
• Install and test lock with door open to avoid being locked out.
A Check door dimensions.
See consumer.schlage.com/Service-Support for door
preparation instructions if dimensions are different.
2³⁄₄” (70 mm)
OR
2³⁄₈” (60 mm)
1” (25 mm)
Door Edge
2¹⁄₈” (53 mm)
Hole
B Change faceplate, if necessary.
Choose the drawing that matches your door edge. If the hole has no
mortise, change to the circular faceplate.
Door Edge
No change
necessary.
OR
Door Edge
Install Lock
1 Install latch.
Make sure latch angle faces door jamb.
3 Install battery.
Jamb
Angle
OR
Actual Size
2 Install strike onto door jamb.
Angle
Wood Block
(Not Included)
4 Install keypad.
Actual Size
Bar should slide smoothly through hole in
latch. If not, check door dimensions.
5 Install lever.
6 If needed, switch levers.
Correct
Incorrect
If your lever looks like this,
then no change is necessary.
If your lever does not look
like this, switch the levers by
following the steps below.
OR
a
Insert the pin wrench
into the hole in the
lever. Push in and
hold.
Actual Size
b c
Pull the lever off. Repeat steps a and b to remove
the lever from the other side of
the door.
Switch the levers.
d
Push each lever back
into place.
Loading...