Schaerer SCA User Manual

Daily cleaning
CAUTION!
User at risk!
SCA / Milk Smart
Schaerer Ltd. P.O. Box
In the beverage dispensing area, there is a danger of scalding due to hot water and steam. Never reach under the dispensers while dispensing or cleaning.
Press - button approx. 4 sec.
Display: "Cleaning programme /
empty gr. container".
Pull out the grounds container within
5 sec seconds and clean it.
Clean brewing chamber with a brush.Insert the grounds container.

Option: Powder system

Display: "Check if mixer is in place".
- Press the button.
Display: "Cleaning programme / in-
sert tablet".
Open the inlet for ground coffee.

Option 1: With lid monitor

Add a cleaning tablet within 15 sec.Close the inlet.

Option 2: Without lid monitor

Insert cleaning tablet - Press the button.

Option 1: With steam and active boiler rinse

Display: "Cleaning programme / hot
rinsing".
Place container (ca. 1 l) under the
steam wand.
- Press the button.
Hot rinsing/cleaning is running (see
display for duration).

Option 2: Without steam; deactivated boiler rinse

Cleaning is running (see display for
duration).
Option 1: Without milk supply / deac­tivated milk system
Continue with step 7.

Option 2: With milk supply / activated milk system

Wait until the following appears in
the display: „Cleaning programme / cleaning agent“.
Fill a mixture of 100 ml Schaerer clean-
ing agent and 1000 ml water in the cleaning container (B).

Option 1: Milk Smart

Place hoses in the cleaning container
(the end of the hose must touch the bottom of the container).
- Press the button.

Option 2: Milk Smart Cooler / Cup+Cool

Open doors.Pull the hose off of the cover.Clean milk container (A).Mount lid and hose on cleaning con-
tainer (B).
Replace cleaning container. - Press the button.
CAUTION!
User at risk!
Cleaning is running (see display for
duration).
"Cleaning programme / rinsing wa-
ter “ appears on the display.
Remove the cleaning container (B),
rinse out and fill with 1000 ml fresh wa­ter.

Option 1: Milk Smart

Repeat Step 5, Opt.1.
Cleaning is running.

Option 2: Milk Smart Cooler / Cup+Cool

Mount lid and hose on cleaning con-
tainer.
Replace cleaning container. - Press the button.
Cleaning is running (see display for
duration).

Option 1: "Automatic switching off after cleaning" deactivated

Continue with step 8.

Option 2: "Automatic switching off after cleaning" activated

The machine switches automatical-
ly to "Stand by".
Begin operating machine with the -
button.
Display: "Remove rinsing water"
Rinse out cleaning container.

Option 1: Milk Smart

Rinse out cleaning container.Clean the outside of the milk hoses
with a damp cloth.
- Press the button.

Option 2: Milk Smart Cooler

Rinse out cleaning container.Clean lid and pipe thoroughly with a
damp cloth.
Mount hose and flap on the milk con-
tainer (A) and put inside.
- Press the button.
Following use of milk beverages or if the milk system is deactivated:
Display: Milk system on / off.

Option 1: Milk system on

- Press the button.

Option 2: Milk system off

- Press the button.
Automatic cleaning finishes.
Improper handling of beans, water, milk, powder or other coffee ingredients can lead to health prob­lems! Observe HACCP hygiene regulations!
See also "Safety instructions" - "HACCP hygiene regulations" in the operating instructions.
Schaerer Ltd. P.O. Box Allmendweg 8 CH-4528 Zuchwil info@schaerer.com www.schaerer.com
Remove foamer head from holder
(press lock to the right).
Pull off the tubes from the foamer head.Disassemble foamer head and clean
under warm, flowing water.
Remove residue with a brush.Reassemble and install the foamer
head (it will "click" upon engaging in place).
Reattach the hose to the foamer head
(do not forget the spring).
Clean the drip grid under warm, run-
ning water.
Clean the drip tray with a moist cloth.

Option: Machine with steam

Wipe the steam wand daily with a
moist, clean cloth.
Press the steam button briefly ± 5
times to remove milk remains.
SCA / Milk Smart | V01 | 05.2012
QRCSCA_MS_d_en
N° 022541
Loading...