Sato RWMTM2 User Manual

Changes or modifications not expressly approved by the

for compliance could void the user's authority to

limits for a Class B digital device, pursuant to Part 15 of the

These limits are designed to provide reasonable

harmful interference in a residential

generates and can radiate radio

and used in accordance

interference to radio

that

If this

television reception, which can be determined by turning the

off and on, the user is encouraged to try to correct

Connect the equipment into an outlet on a circuit different from

technician for

M5e RFID
Radio interface instructions

FCC REQUIREMENT

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.

FCC WARNING:

manufacturer
operate the equipment.

FCC NOTICE:

This equipment has been tested and found to comply with the

FCC Rules.
protection against
installation. This equipment
frequency energy and, if not installed
with instructions, may cause harmful
communications. However, there is no guarantee
interference will not occur in a particular installation.
equipment does cause harmful interference to radio or

equipment
the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

­that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV
help.

This transmitter must not be co-

located or operated in

This equipment complies with FCC radiation exposure limits set

Supplement C to

that it

exposure

should be installed

between the radiator

and person’s body (excluding extremities: hands, wrists, feet

Properly shielded a grounded cables and connectors must be

used for connection to host computer and / or peripherals in

AC adaptor with ferrite core must be used for RF interference

conjunction with any other antenna or transmitter.

forth for uncontrolled equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in
OET65. This equipment has very low levels of RF energy
deemed to comply without maximum permissive
evaluation (MPE). But it is desirable that it
and operated with at least 20cm and more

and ankles).

order to meet FCC emission limits.

suppression.

CE Caution: