Page 1
Keypad and function button
SCAN
1. Scan key
2. Cursor key
3. Control Key
4. Numeric keys
5. Power key
6. User-defined keys
Alpha key
Switches between the character
input mode and the number
input mode [abc][ABC] lit on the
LCD screen indicates the
character input mode. When
[123] is lit, the terminal is in the
number input mode.
Control Key
ESC: The Escape key
6
ENT: The Enter key
BS: The Backspace key
Fn key:
► Fn+Down: Adjust the backlight brightness
► Fn+Left: Reduce the volume.
► Fn+Right: Increase the volume
Reset Key
Power key + Scan key: Warm / Software reset
Power key + Scan key(6 sec up): Cold / Hardware reset
PI-1010/PI-1030 EN 300 328 BT RF Power EIRP 1.92 dbm
PI-1030 EN 300 328 WIFI RF Power EIRP 19.04 dbm
Argox Information Co., Ltd.
7F., No.126, Ln.235, Baoqiao Rd.,
Xindian Dist., New Taipei City 231,
Taiwan (R.O.C.)
Tel: +886-2-8912-1121
Fax: +886-2-8912-1124
http://www.argox.com
See User Manual for more information
Copyright © 2016. Argox Information Co., Ltd. All Rights Reserved.
PI-1010 EN 300 328 BT RF Power EIRP 1.92 dbm
PI-1030 EN 300 328 BT RF Power EIRP 1.92 dbm
PI-1030 EN 300 328 WIFI RF Power EIRP 19.04 dbm
49-PI101-002
Rev. A – May,2018
1
2
3
PI-1000 Series Mobile Computer
Quick Start Guide
4
Depending on the configuration ordered, the PI-1000 Series shipping
container may include:
5
Quick Start Guide Hand strap
USB Cable or
PI-1000
RS-232 Cable with USB power cord
Plug and Power Supply (Accessory)Holder (Option)
Page 2
Attach the hand strap
1. Pinch the small loop and thread it into the two square holes under
the battery cover. Insert the handle of the strap in the thin loop.
2. The strap is fixed to the terminal. Hold the hand strap around the
wrist when carrying the terminal.
LED
Install or replace battery in the terminal
1. Two AA batteries. Recommended alkaline rechargeable type.
2. A fully charged backup battery can maintain memory (RAM)
contents for about 15 minutes, even when the battery pack
is removed. Turn off the terminal to replace battery under
15 minutes.
1. Press and slide two release latch at the same time to open the
battery cover.
LCD
Battery Cover
Keypad
Reading Window
Battery Cover Switch
Connector
First time initiation of this product; please make sure insert fully
charged battery for at least 24 hours to ensure backup battery
properly charged.
Speaker
2. Inserting batteries and close the battery cover as follow.
1
2
3. Make sure cover is closed and slide two latch back.
Loading...