SARGENT FM7100 User Manual

Installation Instructions

FM7100 Series
Multi-Point Lock

For installation assistance, contact SARGENT at 800-727-5477.

A8010 11/13)C (

RH Door Shown

INSIDE

OUTSIDE

RIGHT HAND (RH) RIGHT HAND REVERSE (RHR)

INSIDE

OUTSIDE

LEFT HAND (LH)

INSIDE

OUTSIDE

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

INSIDE

OUTSIDE

LEFT HAND REVERSE (LHR)

This device is intended to be

Tools Supplied

part of an integrated door, frame

and hardware assembly UL­approved for both FEMA 361 and
FEMA 320 guidelines for both in-

swing and out-swing doors.

Tools Required:

Tape Measure

5/32 Hex1/8 Hex 3/16 Hex

Hollow

Tip Driver

Phillips

Head

Marker

Mounting Hardware (Full Scale):

(4)

Oval Head Phillips

12-24x1 1/2"

Flat Head Hex Socket

(5)

12-24x1"

Chisel

(10)

Flat Head Hex Socket

1/4-20x1"

Drill

(2)

Push-on

Retaining

Ring

(1 Spare)

Anchor

Set Tool

Flashlight Mallot

(2)
Drive Pin
(1 Spare)

(2)
Drop-in
Anchor

A8010 11/13)C (

2 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

VERIFY HANDING

Right Hand Door Shown

Left Hand Door Shown

INSIDE OUTSIDE

A8010 11/13)C (

3 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

VERIFY DOOR DIMENSIONS

WARNING

LOCK IN condition can occur and EMERGENCY EGRESS

will be prevented if critical dimensions are not met.

Device will not operate, if door cutouts are not within the

dimensions below.

!

Right Hand Door Shown

40

41 42

43

42" - 42-3/4"

44

45 46

INSIDE OUTSIDE

A8010 11/13)C (

If door does not match above

dimensions, contact door

manufacturer.

4 of 20

37-1/2" - 38-1/4"

36

37 38

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

39

40

41 42 43

1. INSTALL DEADBOLT ASSEMBLY

(2)

Flat Head Hex Socket

1/4-20x1"

Right Hand Door Shown

FM7100

!

WARNING

Deadbolt must

be retracted

before moving

to the next step.

A8010 11/13)C (

5 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

2. INSTALL BOTTOM BOLT ASSEMBLY

(3)

Flat Head Hex Socket

12-24x1"

1

2

Right Hand Door Shown

FM7100

A8010 11/13)C (

6 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

3. ALIGN BOTTOM BOLT ASSEMBLY

Right Hand Door Shown

1

PUSH

2

OR

2

FM7100

A8010 11/13)C (

DOWN

3

UP

7 of 20

PUSH

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

4. PREP TOP ASSEMBLY

1

LAY TOP ROD

2

ON DOOR

3

4

FM7100

Right Hand Door Shown

MARK

CLOSEST HOLE

A8010 11/13)C (

8 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

5. INSTALL TOP ASSEMBLY

(2)

Flat Head Hex Socket

12-24x1"

FM7100

FM7100

Right Hand Door Shown

A8010 11/13)C (

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group

9 of 20

company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

6. ALIGN TOP & BOTTOM ROD PINNING HOLES

Right Hand Door Shown

2

1

PUSH

FM7100

A8010 11/13)C (

GO TO STEP 7

Bottom

Rod

GO TO STEP 6a OR 6b

10 of 20

Top

Rod

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

6a. ADJUST MISALIGNED PINNING HOLES UP

Right Hand Door Shown

2

1

PUSH

FM7100

Top

Rod

Bottom

Rod

3 4

A8010 11/13)C (

=

11 of 20

GO TO STEP 7

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

6b. ADJUST MISALIGNED PINNING HOLES DOWN

Right Hand Door Shown

2

1

PUSH

FM7100

Top

Rod

3

A8010 11/13)C (

Bottom

Rod

=

12 of 20

4

GO TO STEP 7

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

7. PIN THREE ASSEMBLIES

(1)

Push-on

(1)

Drive Pin

Retaining

Ring

INSIDE

FM7100

1

Right Hand Door Shown

8. MOUNT DOOR TO FRAME

OUTSIDE

2

FM7100

A8010 11/13)C (

Right Hand

Door Shown

!

Do not trim

FM7100

13 of 20

door if door

rubs along

floor!

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

9. CHECK FOR HOLD OPEN

1

PUSH

FM7100

FM7100

GO TO STEP 10

A8010 11/13)C (

2

FM7100

3

14 of 20

GO BACK TO

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

1

10. ADJUST DEVICE

1

!

Device Must

Be In HOLD

OPEN Before

Adjusting

Device

!

Hand

Tighten

=

2

A8010 11/13)C (

!

Must

Rotate

Exactly 3

Revolutions

3x

15 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

11. TRIGGER DEVICE & FINAL CHECK

1 2

PUSH

3

PUSH

FM7100

GO BACK TO STEP 10

FM7100

FM7100

FM7100

GO BACK TO STEP 10

A8010 11/13)C (

16 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

12. ASSEMBLE CYLINDER INTO OUTSIDE TRIM

13. MOUNT OUTSIDE AND INSIDE TRIM

INSIDE

(4)

Oval Head Phillips

12-24x1 1/2"

FM7100

OUTSIDE

A8010 11/13)C (

17 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

14. INSTALL TOP LATCH INTO DOOR FRAME

(4)

Flat Head Hex Socket

1/4-20x1"

FM7100

15. ATTACH DEADBOLT STRIKE PLATE TO FRAME

(2)

Flat Head Hex Socket

1/4-20x1"

FM7100

A8010 11/13)C (

18 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

16. PREPARE FLOOR FOR BOTTOM STRIKE

(2)

Flat Head Hex Socket

1/4-20x1"

c

1

a

d

1

2

b

9

e

2

1 2

3

1 2

A8010 11/13)C (

1-1/8" Dia.
x 7/8" Deep

19 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.

17. INSTALL BOTTOM STRIKE

1

O

optional

1/8" Deep

1/4" MAX

Bottom Of Door

To Top of Strike

2

3/8" Dia. x 1-1/2" Deep

3

18. TEST INSTALLATION

FM7100

A8010 11/13)C (

20 of 20

Copyright ©2013, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.