Samsung Electronics 5-1
5. Schematic Diagrams
5-2
5-3
5-4
5-5
5-6
5-7
5-8
5-9
5-10
5-11
5-12
5-13
5-14
5-15
5-16
5-17
5-18
5-19
3 Block Identification of Main PCB - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-1 S.M.P.S. (230 Voltage) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-2 S.M.P.S. (Free Voltage) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-3 Power Drive - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-4 System Control/Servo - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-5 Audio/Video - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-6 Hi-Fi - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-7 TM-Block - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-8 SECAM - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-9 A2/NICAM - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-10 Input-Output - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-11 OSD/VPS/PDC - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-12 OSD (Without VPS/PDC) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-13 Function-Timer (VFD/AV-Link) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-14 Function-Timer (LED) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-15 F-A/V Jack/SRC/Shuttle - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-16 Remote-Control (Multi-TV) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-17 Remote-Control (VCR Only) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Schematic Diagrams
5-2 Samsung Electronics
For schematic Diagram
- Resistors are in ohms, 1/8W unless otherwise noted.
Note
Special note :
Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniques described under the
“electrostatically sensitive (ES) devices” section of this service manual.
Note :
Do not use the part number shown on this drawing for ordering. The correct part number is shown in the parts list (may be slightly different
or amended since this drawing was prepared).
Important safety notices :
Components identified with the mark have the special characteristics for safety. When replacing any of these components.
Use only the same type.
3 Block Identification of Main PCB
Schematic Diagrams
Samsung Electronics 5-3
5-1 S.M.P.S. (230 Voltage)
Schematic Diagrams
5-4 Samsung Electronics
5-2 S.M.P.S. (Free Voltage)
Schematic Diagrams
5-6 Samsung Electronics
FROM/TO F/TIMER (VFD/LED)FROM/TO F/TIMER (LED)
FROM/TO F/TIMER (VFD)
FROM/TO F-A/V JACK
FROM/TO SHUTTLE