SAMSUNG LTN133AT08-001 Specification

Global LCD Panel Exchange Center

W. B . Youn

www.panelook.com

Approval

TO

DATE

SAMSUNG TFT-LCD

SAMSUNG TFT-LCD

MODEL NO. : LTN133AT08-001

MODEL NO. : LTN133AT08-001

NOTE :

NOTE : - Surface type [ Glare ]

: Lenovo / Quanta

th

: Mar. 14

Green product (Complied with RoHS requirement)

, 2007.

Any Modification of Spec is not allowed without SEC’ permission

APPROVED BY :

PREPARED BY : LCD Development Team3

SAMSUNG ELECTRONICS CO., LTD.

Samsung Secret

Doc.No. Rev.No

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

04-A00-G-070314

Page

www.panelook.com

/ 30LTN133AT08-001

1

Global LCD Panel Exchange Center

CONTENTS

www.panelook.com

Approval

Revision History

General Description

1. Absolute Maximum Ratings

1.1 Absolute Ratings of environment

1.2 Electrical Absolute Ratings

2. Optical Characteristics

3. Electrical Characteristics

3.1 TFT LCD Module

3.2 Backlight Unit

3.3 Inverter

4. Block Diagram

4.1 TFT LCD Module

4.2 Backlight Unit

4.3 Inverter Unit

5. Input Terminal Pin Assignment

5.1 Input Signal & Power

5.2 LVDS Interface

5.3 Backlight Unit

5.4 Timing Diagrams of LVDS For Transmitting

5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.

5.6 Pixel format

-------------------( 3 )

-------------------( 4 )

-------------------( 5 )

-------------------( 7 )

-------------------( 10 )

-------------------( 13 )

-------------------( 14 )

6. Interface Timing

6.1 Timing Parameters

6.2 Timing Diagrams of interface Signal

6.3 Power ON/OFF Sequence

7. Outline Dimension

8. Packing

9. Markings & Others

10. General Precaution

11. EDID

Samsung Secret

Doc.No. Rev.No

-------------------( 20 )

-------------------( 21 )

------------------- ( 23 )

------------------- ( 24 )

-------------------( 26 )

-------------------( 28 )

04-A00-G-070314

Page

/ 30LTN133AT08-001

2

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

REVISION HISTORY

REVISION HISTORY

LTN133AT08-001 Model spec was issue first.AllA00Mar.14th. 2007

Approval

SummaryPageRevision No.Date

Samsung Secret

Doc.No. Rev.No

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

04-A00-G-070314

Page

www.panelook.com

/ 30LTN133AT08-001

3

Global LCD Panel Exchange Center

GENERAL DESCRIPTION

DESCRIPTION

LTN133AT08-001 is a color active matrix TFT (Thin Film Transistor) liquid crystal display
(LCD) that uses amorphous silicon TFT as a switching devices. This model is composed of
a TFT LCD panel, a driver circuit and a backlight unit. The resolution of a 13.3" contains
1,280 x 800 pixels and can display up to 262,144 colors. 6 O'clock direction is the Optimum

viewing angle.

FEATURES

• High contrast ratio, high aperture structure

• 1280 x 800 pixels resolution

• Low power consumption

• Fast Response

• Single CCFL

• DE(Data enable) only mode

• 3.3V LVDS Interface

• Onboard EEDID chip

www.panelook.com

Approval

APPLICATIONS

• Notebook PC

• If the usage of this product is not for PC application, but for others, please contact SEC.

GENERAL INFORMATION

Display area

Driver element

Display colors

Number of pixel

Pixel arrangement

Pixel pitch

a-Si TFT active matrix

262,144

RGB vertical stripe

mm268.08(H) x 178.80(V) (13.3” diagonal )

113.6DPImm0.2235(H) x 0.2235(V) (TYP.)

NoteUnitSpecificationItem

16 : 10pixel1280 x RGB(3) x 800

Display Mode

Surface treatment

Samsung Secret

Doc.No. Rev.No

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

Normally white

04-A00-G-070314

GlareHaze 0, Hard-Coating 3H

Page

/ 30LTN133AT08-001

4

www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Mechanical Information

Module

size

Weight 365

1. ABSOLUTE MAXIMUM RATINGS

1.1 ENVIRONMENTAL ABSOLUTE RATINGS

Operating temperate

(Temperature of glass surface)

Max.

299.5

195.5

5.5

Approval

NoteUnitTyp.Min.Item

mm299.0298.5Horizontal (H)

mm195.0194.5Vertical (V)

mm--Depth (D)

g350-

NoteUnitMax.Min.SymbolItem

(1)qC60-20 TSTGStorage temperate

(1)qC500TOPR

Note (1) Temperature and relative humidity range are shown in the figure below.

95 % RH Max. (40 qC t Ta)
Maximum wet - bulb temperature at 39

100

-40 -20 0 20 40 60 80

Relative Humidity ( %RH)

90

80

60

40

20

Operating Range

Storage Range

5

0

Temperature (

O

C or less. (Ta ! 40 qC ) No condensation

( 40,90 )

( 50,50.4 )

( 60,27.7 )

O

C)

(2),(4)G240-SnopShock ( non-operating )

(3),(4)G2.41-VnopVibration (non-operating)

(2) 2ms, half sine wave, one time for rX, rY, r Z.
(3) 5 - 500 Hz, random vibration, 30min for X, Y, Z.
(4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be

hard and rigid enough so that the Module would not be twisted or bent by the fixture.

Samsung Secret

Doc.No. Rev.No

04-A00-G-070314

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

Page

/ 30LTN133AT08-001

5

www.panelook.com

Global LCD Panel Exchange Center

1.2 ELECTRICAL ABSOLUTE RATINGS

(1) TFT LCD MODULE

www.panelook.com

Approval

DD =3.3V, VSS = GND = 0V

V

NoteUnitMax.Min.SymbolItem

DDPower Supply Voltage

Note (1) Within Ta (25 r 2 qC)

(2) BACK-LIGHT UNIT

LLamp Current

Note 1) Permanent damage to the device may occur if maximum values are exceeded

Functional operation should be restricted to the conditions described under normal operating conditions.

(1)V3.6VSS - 0.3V

Ta = 25 r 2 qC

NoteUnitMax.Min.SymbolItem

(1)mArms7.02.0I

(1)kHz8040FLLamp frequency

Samsung Secret

Doc.No. Rev.No

04-A00-G-070314

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

Page

/ 30LTN133AT08-001

6

www.panelook.com

Global LCD Panel Exchange Center

2. OPTICAL CHARACTERISTICS

The following items are measured under stable conditions. The optical characteristics
should be measured in a dark room or equivalent state with the methods shown in Note (5).
Measuring equipment : TOPCON BM-5A and PR-650

www.panelook.com

Approval

* Ta = 25 r 2 qC, VDD=3.3V, fv= 60Hz, fDCLK = 48.15MHz, IL = 6.0 mArms

Contrast Ratio

(5 Points)

Response Time at Ta

( Rising + Falling )

Average Luminance

of White (5 Points)

Red

Color

Green

Chromaticity

( CIE )

Blue

CR

RT_B/W

L,AVE

Y

Y

Normal

Viewing

Angle

I = 0
T = 0

Unit

-

msec

-250220Y

cd/m

2

NoteMaxTyp.Min.ConditionSymbolItem

(1), (2), (5)--300

(1), (3)3525-T

L=6.0mA

I

(1), (4)

0.6150.5850.555RX

0.3700.3400.310R

0.3550.3250.295GX

0.5700.5400.510G

-

0.1810.1510.121BX

(1), (5)

PR-650

0.1630.1330.103BY

X

White

Y

W

T

L

Hor.

Viewing

Angle

R

CR t 10

Ver.

L

13 Points

White Variation

L

Samsung Secret

Doc.No. Rev.No

0.3430.3130.283W

0.3590.3290.299

04-A00-G-070314

-4540

-4540T

-1510IH

Degrees

(1), (5)
BM-5A

-3025I

-

Page

(6)1.8--G

/ 30LTN133AT08-001

7

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

www.panelook.com

Global LCD Panel Exchange Center

d

www.panelook.com

Note 1) Definition of Viewing Angle : Viewing angle range( 10

C/R, 100 dC/R )

Normal Line
I = 0

o

,

T = 0

o

T L

T R

TL=90

o

x

I L

I H

y

12 O’clock
direction

IH= 90

6 O’clock
direction

IL= 90

o

x'y'

=90

T

R

Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)

at 5 points(4, 5, 7, 9, 10)

CR(4) + CR(5) + CR(7) + CR(9) + CR(10)

CR =

5

Approval

o

o

Points : , , , , at the figure of Note (6).

4 9

5

7

10

Note 3) Definition of Response time :

Display data

White(TFT OFF)

TR

Black(TFT ON)

White(TFT OFF)

TF

100%

90%

Optical
Response

10%

0%

Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.

320 640 960

VIEW AREA

Average Luminance of White ( YL,AVE )

10

9

200

Time

L4 + YL5 + YL7 + YL9 + YL10

Y

7

YL,AVE =

5

5

4

600

(lines)

: test point

Samsung Secret

Doc.No. Rev.No

04-A00-G-070314

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

400

Page

/ 30LTN133AT08-001

8

www.panelook.com

Global LCD Panel Exchange Center

Note 5) After stabilizing and leaving the panel alone at a given temperature for 30 min , the measurement

should be executed. Measurement should be executed in a stable, windless,and dark room.
30 min after lighting the backlight. This should be measured in the center of screen.
Lamp current : 6.0mA ( Inverter : SIC-130T )
Environment condition : Ta = 25 r 2 qC

Photo-detector

( TOPCON BM-5A

PR-650 )

www.panelook.com

Field

= 2q

Approval

50 cm

TFT-LCD module

Center of the screen

[ Optical characteristics measurement setup ]

Note 6) Definition of 13 points white variation (G L ), CR variation( CVER ) [ ~ ]

Maximum luminance of 13 points

LCD panel

113

G L =

Minimum luminance of 13 points

10mm

11

200

10mm

10mm

320 640

13 12

10

960

9

8

5

3

10mm

Samsung Secret

Doc.No. Rev.No

7

4

2

04-A00-G-070314

6

400

600

(lines)

1

: test point

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!

Page

/ 30LTN133AT08-001

9

www.panelook.com