To avoid the risk of accidents or damage to the hob, read all instructions before
installing or using the appliance. Keep this manual for future reference.
Please take the time to read this owner’s manual, paying particular attention to the safety
EN
information contained in the following section, before using your appliance. Keep this manual
for future reference. If transferring ownership of the appliance, please remember to pass the
manual on to the new owner.
The following symbols are used in the text
This is the safety alert symbol.
Warning indicates information concerning your personal safety.
Important indicates information on avoiding damage to the appliance.
This symbol indicates useful information and practical tips.
This symbol refers to measures that can be taken to help protect the environment.
1. Numbers like these indicate step - by - step instructions for using the appliance.
...
2.
...
3.
This manual contains information on steps you can take yourself to diagnose and resolve
problems that may arise. Refer to the section “Troubleshooting.”
2
3
EN
Safety
The safety aspects of this appliance comply with accepted technical standards and
the German Appliance Safety Law. However, as manufacturers we also believe it is
our responsibility to familiarise you with the following safety instructions.
Electrical safety
• Be sure the appliance is properly installed and grounded by a qualied technician.
The appliance should be serviced only by qualied service personnel. Repairs carried
•
out by unqualied individuals may cause injury or serious malfunction. If your appliance
is in need of repair, contact your local service centre. Failure to follow these instructions
may result in damage and void the warranty.
•
Flush - mounted appliances may be operated only after they have been installed in
cabinets and workplaces that conform to the relevant standards. This ensures sufcient
protection against contact for electrical units as required by the TÜV [Technical
Inspection Association].
•
If your appliance malfunctions or if fractures, cracks or splits appear:
- switch off all cooking zones;
- disconnect the hob from the mains supply and contact your local service centre.
• If the hob cracks, turn the appliance off to avoid the possibility of electric shock. Do not
use your hob until the glass surface has been replaced.
Do not use the hob to heat aluminium foil, products wrapped in aluminium foil or frozen
•
foods packaged in aluminium cookware.
Child safety
This appliance is not intended for use by young children or inrm persons without the
adequate supervision of a responsible adult.
Young children should be supervised to ensure that they do not play with the appliance.
The cooking zones will become hot when you cook. Always keep small children away
from the appliance.
Safety (continued)
EN
Safety during use
• This appliance is to be used only for normal cooking and frying in the home. It is not
designed for commercial or industrial use.
• Never use the hob for heating the room.
• Take care when plugging electrical appliances into mains sockets near the hob. Mains
leads must not come into contact with the hob.
• Overheated fat and oil can catch re quickly. Never leave surface units unattended
when preparing foods in fat or oil, for example, when cooking chips.
• Turn the cooking zones off after use.
• Always keep the control panels clean and dry.
Never place combustible items on the hob. It may cause re.
•
The appliance is not intended for use by persons (including children) with reduced
•
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Safety when cleaning
• Always turn the appliance off before cleaning.
For safety reasons do not clean the appliance with a steam jet or high - pressure
•
cleaner.
•
Clean the hob in accordance with the cleaning and care instructions contained in this
manual.
Disposal Instructions
Disposing of the packaging material
• All materials used to package the appliance are fully recyclable. Sheet and hard foam
parts are appropriately marked. Please dispose of packaging materials and old
appliances with due regard to safety and the environment.
Proper disposal of your old appliance
Warning: Before disposing of your old appliance, make it inoperable so that it cannot be a
source of danger.
To do this, have a qualied technician disconnect the appliance from the mains supply and
remove the mains lead.
• The appliance may not be disposed of in the household rubbish.
Information about collection dates and public refuse disposal sites is available from your
•
local refuse department or council.
4
5
EN
Installing the Hob
Important: Be sure the new appliance is installed and grounded only by qualied
personnel.
Please observe this instruction. The warranty will not cover any damage that may
occur as a result of improper installation.
Technical data is provided at the end of this manual.
Regulations and compliance
This appliance meets the following standards:
EN 60 335 - 1 and EN 60 335 - 2 - 6, relating to the safety of electrical appliances for
•
household use and similar purposes;
EN 60350, or DIN 44546 / 44547 / 44548, relating to the operating features of electric
•
cookers, hobs, ovens, and grills for household use;
EN 55014 - 2;
•
EN 55014;
•
EN 61000 - 3 - 2; and
•
• EN 61000 - 3 - 3, relating to basic requirements for electromagnetic compatibility (EMC).
This appliance complies with the following EU Directives:
• With respect to re protection, this appliance corresponds to EN 60 335 - 2 - 6. This type of
appliance may be installed with a high cupboard or wall on one side.
•
Drawers may not be tted underneath the hob.
• The installation must guarantee shock protection.
The kitchen unit in which the appliance is tted must satisfy the stability requirements of
•
DIN 68930.
• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.
On tiled work surfaces, the joints in the area where the hob sits must be completely lled
•
with grout.
•
On natural, articial stone, or ceramic tops, the snap action springs must be bonded in
place with a suitable articial resin or mixed adhesive.
• Ensure that the seal is correctly seated against the work surface without any gaps.
Additional silicon sealant must not be applied; this would make removal more difcult when
servicing.
• The hob must be pressed out from below when removed.
• A board is to be installed underneath the hob.
Installing the Hob (Continued)
273
min. 20
600
50
+1
R3
490
+1
x4
x490
2
100
100
490
+1
=
=
EN
Connecting to the outlet
Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated
on the rating plate, corresponds to the available supply voltage. The rating plate is located on
the lower casing of the hob.
The heating element voltage is AC240 V~. This appliance is equipped with a cord that includes
a grounding wire and a grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded.
Once the hob is connected to the mains supply, check that all cooking zones are
ready for use by briey switching each on in turn at the maximum setting.
When the hob is powered on for the rst time, all displays light and the child safety
lock is activated.
Installing into the countertop
Make a note of the serial number on the appliance rating plate prior to installation.
This number will be required in the case of requests for service and is no longer
accessible after installation, as it is on the original rating plate on the underside of the
appliance.
Pay special attention to the minimum space and clearance requirements.
Secure the brackets at both sides with the provided screws before mounting the hob
onto the brackets.
min. 50mm
6
7
EN
Parts and Features
Cooking zones and control panel
Control panel
Single cooking zone
1950W
Single cooking zone
1300 W
Timer indicator and
control sensors
Indicators for heat settings
and residual heat
Heat setting selectors
“Lock” control sensor
“On/Off” control sensor
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.