Samsung 794MBplus, 796MBplus, 798MB Service manual Disassembly

11 Disassembly and Reassembly

11-1

11-1 Disassembly

WARNING: This monitor contains electrostatically sensitive devices. Use caution when

handling these components.

Cautions: 1. Disconnect the monitor from the power source before disassembly.

2. Follow these directions carefully; never use any metal instrument except provided
jig to separate the cabinet.

3. R/Cover opening jig : BH81-00001A

11 Disassembly and Reassembly

This section of the service manual describes the disassembly and reassembly procedures for the
KS17CNK, KS17CNJ, KV17CNK CDT monitor.

1. Release the snaps on the rear stand and pull the
stand backwards from the monitor and remove 2
screws from the rear top shield.

2. Insert the opining jig into the grooves at each side
and press until it cilcks and lift up the rear cover.

3. Remove 2 screws from the shield and lift up the
shield.

4. Disconnect 3 ground from the shield video and
carefully remove the silicon glue on the CDT
socket with a razor.

Caution : CDT socket may be easily
damaged. Please use caution when remoning the
silicon glue.

11 Disassembly and Reassembly

11-2

5. High voltage may be present.

Caution : Remove the high voltage cap from

the CDT.

6. Disconnect DY cable, D-COIL cable from the
CDT socket. Using the jig, release the snaps
connecting the front cover and the PCB. Lift up the
bottom to separate the two shields.

7. Disconnect function wire connecter from the
MAIN board. Remove 4 screws from the front
cover.

8. Remove CDT from the front cover.

11-2 Reassembly

Reassembly procedures are in the reverse order of disassembly procedures.