Ryobi RLT254CSEON Original Instructions Manual
ORIGINAL INSTRUCTIONS
RLT254CSEON
25.4CC GRASS TRIMMER
Important!
It is essential that you read the instructions in this manual before
assembling, maintaining and operating this machine.
2
English (Original Instructions)
SYMBOLS
Important: Some of the following symbols may be used on your product. Please study them and learn their meaning.
Proper interpretation of these symbols will allow you to operate the tool better and safer.
Safety alert
Read and understand all instructions before operating the product. Follow all warnings and
safety nstructions.
Wear eye, hearing, and head protection when operating this product.
Wear non-slip safety footwear when using the product.
Wear non-slip, heavy-duty gloves.
Beware of thrown or flying objects. Keep all bystanders, especially children and pets, at least 15
m away from the operating area
The product is not intended for use with a toothed saw type blade.
Do not use metal blade (s) on the product
Rotational direction and maximum speed of the shaft for the cutting attachment.
Use unleaded gasoline intended for motor vehicle use with an octane rating of 91 ([R+M]/2) or
higher.
Use full synthetic 2-stroke lubricant for air cooled engines.
Mix the fuel mix thoroughly and also each time before refuelling.
Keep hands away from blades.
Run position
Set the choke lever to “FULL” choke position.
Set the choke lever to "HALF" choke position.
3
English (Original Instructions)
Press the primer bulb 10 times.
Squeeze the throttle lock and throttle trigger to run.
Wait 10 seconds.
Pull: Quick release tab
Regulatory Compliance Mark (RCM). This product meets applicable regulatory requirements.
75 dB
Sound pressure level at idle
115 dB
Guaranteed sound power level
When fitting the line spool to the cutting means, this symbol should be visible to the operator.
Pull the starter grip.
To reduce the risk of injury or damage, avoid contact with any hot surface.
Starting a warm engine by electrical starter
Starting a cold engine by electrical starter
Starting a warm engine by hand
Starting a cold engine by hand
The following signal words and meanings are intended to explain the levels of risk associated with the product.
SYMBOLS SIGNAL MEANING
DANGER
Indicates an imminently hazardous situation, which, if not avoided, will
result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not avoided, could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not avoided, may
result in minor or moderate injury.
CAUTION
(Without Safety Alert Symbol) Indicates a situation that may result in
property damage.
4
English (Original Instructions)
the string head.
■ Wear full eye and hearing protection while operating
this product. If working in an area where there is a risk
of falling objects, head protection must be worn.
■ Hearing protection may restrict the operator’s ability
to hear warning sounds, pay particular attention to
potential hazards around and inside the working area.
■ Wear heavy long trousers, non-slip protective footwear
and gloves. Do not wear loose fitting clothing, short
trousers, jewellery of any kind, or use with bare feet.
■ Secure long hair so it is above shoulder level to
prevent entanglement in any moving parts.
■ Keep all bystanders, children, and pets at least 15 m
away. Stop the product if anyone enters the area.
■ Do not operate this product when you are tired, ill, or
under the influence of alcohol, drugs, or medication.
■ Do not operate in poor lighting. The operator needs
clear unrestricted vision to identify potential hazards.
■ Keep firm footing and balance at all times. Do not
overreach. Overreaching can result in loss of balance
or exposure to hot surfaces.
■ Keep all parts of your body away from any moving part.
■ Do not touch area around the silencer or cylinder of the
product, these parts get hot from operation.
■ Always stop the engine and allow it to cool before
making any adjustments.
■ Do not smoke when mixing fuel or filling fuel tank.
■ Mix and store fuel in a container approved for fuel.
■ Mix fuel outdoors where there are no sparks or flames.
Wipe up any fuel spillage. Move 9 m away from
refueling site before starting engine.
■ Stop the engine and allow to cool before refueling or
storing the product.
■ Allow the engine to cool; empty the fuel tank and
secure the product from moving before transporting in
a vehicle.
■ Always stop the engine and make sure all moving
parts have come to stop before:
● servicing
● leaving the product unattended
● cleaning your product
● changing accessories
● clearing blockages
● checking for any damage after hitting an object
4
Safety, performance, and dependability have been given
top priority in the design of your grass trimmer.
INTENDED USE
This grass trimmer is intended to be used only by
adults who have read and understood the instructions
and warnings in this manual and can be considered
responsible for their actions. This product is only intended
for use outdoors in a well ventilated area. For safety
reasons, the product must be adequately controlled by
using two-handed operation.
The grass trimmer is designed for cutting grass, light
weeds, and other similar vegetation at or about ground
level. The cutting plane should be approximately parallel
to the ground surface.
The grass trimmer should not be used to cut or trim
hedges, bushes, or other vegetation where the cutting
plane is not or about ground surface level.
WARNING
To reduce the risk of injury, the user must read
and understand the operator’s manual.
WARNING
Do not attempt to operate the product until you
have read thoroughly and understood completely
all instructions and safety rules contained in this
manual. Failure to comply may result in accidents
involving re, electric shock, or serious personal
injury. Save the operator’s manual and review
frequently for continuing safe operation, and
instructing others who may use the product.
WARNING
The product is not intended to be used by
children or persons with reduced physical, mental,
or sensory capabilities. Children should be
adequately supervised to ensure they do not play
with the product.
GENERAL SAFETY RULES
■ For safe operation, read and understand all instructions
before using the product. Follow all safety instructions.
Failure to follow all safety instructions listed below, can
result in serious personal injury.
■ Some regions have regulations that restrict the use of
the product. Check with your local authority for advice.
■ Do not allow children or untrained individuals to use
the product.
■ Never start or run the engine in a closed or poorly
ventilated area; breathing exhaust fumes can kill.
■ Clear the work area before each use. Remove all
objects such as rocks, broken glass, nails, wire, or
string, which can be thrown or become entangled in
5
English (Original Instructions)
● checking for any damage if the product starts to
vibrate abnormally
● performing maintenance
WARNING
Never use cutting means or attachments which
are not specied by Ryobi in this manual. This
includes the use of metal multi-piece pivoting
chains and ail-blades. These items are known
to break up during use and present a high risk of
serious injury to the operator or bystanders.
WARNING
Inspection after dropping or other impacts:
Thoroughly inspect the product and identify
any problems or damage to it. Any part that
is damaged should be properly repaired or
replaced by an authorised service centre.
TRIMMER SAFETY WARNINGS
■ Replace the string head if cracked, chipped, or
damaged in any way. Be sure the string head is
properly installed and securely fastened. Failure to do
so can cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length for safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before use and after any impact, check that there
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
switch or any part that is damaged should be properly
repaired or replaced by an authorised service facility.
■ Make sure the head attachment is properly installed
and securely fastened.
■ Make sure all guards, deflectors, handles, bolts, and
fasteners are properly and securely attached.
■ Do not modify the product in any way. This may
increase the risk of injury to yourself or others.
■ Use only the manufacturer’s replacement line in the
cutting head. Do not use any other cutting attachment.
■ Never operate product without the cutting attachment
guard in place and in good condition.
5
■ Maintain a firm grip on both handles while trimming.
Keep string head below waist level. Never cut with
the string head located over 76 cm or more above the
ground.
■ The grass trimmer is fitted with a harness. Carefully
adjust the harness to fit comfortably and help to
support the weight of the machine at your right side.
■ Identify the Quick Release mechanism and practice
using it before you start using the product. Its
correct use may prevent serious injury in case of
an emergency. Never wear additional clothing over
the harness or otherwise restrict access to the quick
release mechanism.
TRANSPORTATION AND STORAGE
■ Stop the engine, and allow it to cool before storing or
transporting.
■ Clean all foreign material from the product.
■ Drain all fuel from tank into a container approved for
petrol. Remember to properly replace and tighten the
fuel cap.
■ Run the engine until it stops, this will remove all fuel
that could become stale and leave varnish and gum
in the fuel system.
■ Store the product in a cool dry and well-ventilated
place that is inaccessible to children. Keep away from
corrosive agents such as garden chemicals and deicing salts. Do not store outdoors.
■ When transporting the product, secure it against
movement or falling to prevent injury to persons or
damage to the product.
■ Never transport the product while the engine is
running.
■ Abide by all government and local regulations for the
safety storage and handling of petrol.
SHORT TERM
■ Stop the engine, and allow it to cool before storing.
■ Clean all foreign material from the product.
■ Store the product in a cool dry and well-ventilated
place that is inaccessible to children.
■ Keep away from corrosive agents such as garden
chemicals and deicing salts.
■ Do not store outdoors.
Loading...