Russell hobbs 14337 User Manual

instructions

2

3

Read the instructions and keep them safe. If you pass the processor on, pass on the
instructions too. Remove all packaging, but keep it till you know the processor works.

important safeguards

Follow basic safety precautions, including:

1 This processor must only be used by or under the direct supervision of a responsible

adult. Use and store the processor out of reach of children.

2 Don’t put the motor unit in water, don’t use it in a bathroom or near any

source of water, and don’t use it outdoors.

3 Use and store the processor out of reach of children.

4 Don’t open the processor till the blades have stopped moving.

5 Don’t handle the blades. There’s plenty of plastic – handle that instead.
6 The blades are very sharp. Take care when you’re handling and cleaning

the blade units – if you can’t see what you’re doing, don’t do it.

7 The motor will not operate unless the processor has been properly assembled. This

is a safety feature – do not attempt to overcome it.
8 Unplug before dismantling or cleaning.
9 Don’t leave the processor unattended while plugged in.

10 This processor is designed to process small quantities of food. Larger quantities may

be processed in batches, but it shouldn’t be used instead of a full size processor. Do

this and you’ll break it.

11 Don’t fill with anything hotter than you can comfortably handle (i.e. liquid

temperature below 40°C).

12 Don’t try to chop raw meat.
13 Don’t process big bits – nothing bigger than about 12mm (half inch) cubes.
14 Don’t fill above the max mark.
15 Don’t run the motor for more than 1 minute at a time, then leave it for 3 minutes to

cool down before using it again.

16 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.
17 Don’t fit any attachment or accessory other than those we supply.
18 Don’t use the processor for any purpose other than those described in these

instructions.

19 Keep the processor and the cable away from hotplates, hobs or burners.
20 Don’t use the processor if it’s damaged or malfunctions.
21 If the cable is damaged, the processor must be returned, in order to avoid hazard.

household use only

before using for the first time

• Pull the blade guard carefully off the blades, and dispose of the blade guard.

• Turn to “care and maintenance” on page 5 and clean the blender, to remove any

manufacturing residues, dust, etc.