Page 1
Copyright © 2007 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in
any form without the written permission of ROLAND CORPORATION.
Connection Guide
When connecting the SA-1000 with other equipment, be sure to read
the owner's manuals for the SA-1000 and each device being connected.
1
Turn O the Power to All Devices
Turn down the VOLUME knobs on all devices being connected to lower the
volume completely, then turn o their power.
SA-1000's Control Panel
Turn all VOLUME knobs to MIN Turn o the power
Also lower the VOLUME on the keyboard you're connecting
to the minimum level, then turn o the power. Be sure to
refer to the owner's manual for the keyboard you're
connecting before carrying out this procedure.
Keyboard to
be connected
Page 2
２
Use a connecting cable (optional) with 1/4" phone plugs to connect the
keyboard's output jacks to the SA-1000's KEYBOARD IN jacks.
Connect the Keyboard
To KEYBOARD IN jacks on rear panel
The name and shape of the jacks can vary depending
*
on the keyboard. For details, refer to the owner's
manual that came with the keyboard you're connecting.
Commercially available
connecting cable
To keyboard's
output jacks
Connect the Subwoofer (SA-1000W)
Rear panel
Use the dedicated
cable included with
the amp to connect
the SA-1000 and
SA-1000W.
Page 3
3
Turn on the power to the devices in the sequence described below. Switch
on the power according to the instructions in the owner's manuals for the
SA-1000 and each device being connected.
2
Next, turn on the power
to the SA-1000.
Turn on the Power
1
First, turn on the power
to the keyboard.
3
Lastly, turn on the power to the SA-1000
connected through Stereo Link.
When Connecting a Second SA-1000 with Stereo Link
To STEREO LINK OUT TO
SIDE R jack on rear panel
Commercially available
connecting cable
To STEREO LINK IN
jack on rear panel
The SA-1000 is connected to the SA-1000
on the left, as seen from the audience.
Page 4
4
Adjust the Volume
First, raise the keyboard's volume, then increase the SA-1000's INPUT
VOLUME settings.
Raise the keyboard's volume to 60-70% of the
maximum level. However, if speakers are
connected, set the volume to a listenable level.
If using Stereo Link, the settings for the MASTER section of
both SA-1000s need to be set so they match.
Raise the volume to 60%-70%
of the maximum level.
Adjust the overall volume level
with the MASTER VOLUME knob.
SD001051 2DH
Loading...