Roland OP-R09HR-W User Manual

WIND SHIELD for R-09HR		R-09HR OP-R09HR-C
OP-R09HR-Ws’ ManualOwner		Use of this product with the R-09HR requires the optional OP-R09HR-C cover/stand set.

R-09HR

R-09HR OP-R09HR-C

This wind shield is for use with the R-09 audio recorder when it has been placed inside the specially designed OP-R09C case (sold separately).

It is made of special material that allows sound to pass through while keeping wind out, significantly reducing unwanted wind noise.

•

Main material

• Polyurethane

*In the interest of product improvement, the specifications and/or appearance of this product are subject to change without prior notice.

Copyright ©2008 ROLAND CORPORATION

All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.

© 2008

*

5 1 0 0 0 0 4 3 7 3

-

0 1

*

OP-R09HR-W

Attaching the OP-R09HR-W

OP-R09HR-C R-09HR

Fit the wind shield over the R-09HR with its cover (OP-R09HR-C) attached. Be sure to orient the wind shield correctly.

	2	R-09HR

Display

Push the wind shield onto the R-09HR so that the opening of the shield coincides with

the display of the R-09HR.

Opening

of the shield

OP-R09M

If you're using a tripod or the mic stand adapter (OP-R09M), attach it through the opening on the back side.

Make sure that the ring does not reach the inside of the wind shield.

Ring

Opening on the back side

Important Notes

Placement

Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat can deform or discolor the unit.