RocketFish RF-TVMLPT01 User Manual
QUICK SETUP GUIDE
RF-TVMLPT01
Thank you for choosing the
Rocketsh RF-TVMLPT01.
The RF-TVMLPT01 TV mount
is designed to support
a TV weighing up to
50 lbs. (22.7 kg).
1 Install locking screw
Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H).
Do not screw in more than three or four turns.
G
H
Option 2: If the back of the TV is curved or to make room for cables
Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D).
Note: If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used.
Package contents
A TV bracket (1)
B Wall plate (1)
M4 bag
C M4 x 12 mm screws (4)
D M4 x 30 mm screws (4)
E M4 washers (4)
F M4 spacers (4)
Miscellaneous bag
G Locking screw (1)
H 5/32 in. hex key (1)
Lag bolt bag
I 5/16 in. x 2¾ in. lag bolts (2)
J Concrete anchors (2)
A
M4 bag
C
M4 x 12mm
Miscellaneous bag
G
Lag bolt bag
D
M4 x 30mm
H
E
in.
B
M4
2 Attach the TV bracket
Option 1: If the back of the TV is at
Align the TV bracket (A) with the mounting screw holes
on the back of the TV. Place the washers (E) over
the screw holes on the TV bracket.
Note: If the hole pattern on your TV is 75 mm x 75 mm,
do not use the washers. Insert the screws (C) though
the screw holes and tighten.
A
F
E
D
F
A
D
F
M4
With washers
E
C
Without washers
A
Tools you will need:
• Stud nder
• Awl
• Level
• Pencil
• Hammer (Concrete Only)
• Tape measure
• Power drill
• 3/16 in. wood drill bit
I
J
C
Without washers
• 3/8 in. masonry
drill bit(Concrete Only)
• Socket wrench with ½ in. socket
or adjustable wrench
• Phillips screwdriver
A
With washers
3 Install the wall plate
Option 1: Installing to a wood stud wall
Caution: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts.
Any material covering the wall must not exceed 5/8 in. (16mm).
a. Locate the stud. Verify the center of the stud with
an awl or thin nail or use an
edge-to-edge stud nder.
b. Level the wall plate (B)
and mark the hole
locations.
c. Drill the pilot holes
as illustrated.
d. Align the wall plate
with the pilot holes,
insert the lag bolts
(I) through the holes
in the wall plate, then
tighten the lag bolts
with a socket wrench
only until they are pulled
rmly against the wall
plate.
b.
B
d.
a.
c.
< 16 mm
5
(
⁄8 in.
Option 2: Installing to a solid concrete or concrete block wall
Caution: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts.
Any material covering the wall must not exceed 5/8 in. (16mm).
)
a.
Caution: To prevent property damage
B
or personal injury, never drill into
mortar between blocks.
b.
c.
J
< 16 mm
5
(
⁄8 in.
)
a. Level the wall plate (B) and mark
the hole locations.
b. Drill the pilot holes as illustrated.
c. Insert the concrete wall anchors
(J) into the pilot holes and use a
hammer to make sure that the
anchors are seated ush with the
concrete surface.
d. Align the wall plate with the
anchors, insert the lag bolts (I)
through the holes in the wall
plate, then tighten the lag bolts
with the socket wrench only until
they are pulled rmly against the
wall plate.
5 Adjust the tilt angle (if necessary)
You can adjust the tilt angle of the screen ± 12°.
If necessary, the tilt tension can be adjusted by tightening or
loosening the tension knob with either the hex key (H) or by
hand.
d.
J
H
I
4 Mount the TV to the wall
a.Slide the TV/wall bracket assembly down over the
tabs on the wall plate (B), then tighten the locking
screw with the hex key (H).
a.
HEAVY! You will need
assistance with this step.
75mm
3 in.
75mm
3 in.
I
IMPORTANT SAFETY INSTRUCTIONS • SAVE THESE INSTRUCTIONS
Caution: Do not use this product for any purpose not explicitly specied by Rocketsh. Improper installation
may cause property damage or personal injury. If you do not understand these directions, or have doubts
about the safety of the installation, contact Customer Service or call a qualied contractor. Rocketsh is not
responsible for damage or injury caused by incorrect installation or use. The weight of your TV must not
exceed 50 lb (22.7 kg). The wall must be capable of supporting ve times the weight of the TV and wall
mount combined.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from
young children!
5-year limited warranty
Visit www.rocketshproducts.com for details.
We’re here for you
www.rocketshproducts.com
For customer service, call:
800-620-2790 (U.S./Canada markets)
B
H
G
01 800-926-3010 (Mexico market)
© 2010 BBY Solutions, Inc., All Rights Reserved.
Distributed by Best Buy Purchasing, LLC 7601 Penn Avenue South, Richeld, MN USA 55423-3645
Best Buy Imports, S. de R.L. de C.V. Av. Santa Fe 485, Segundo Piso, Colonia Cruz Manca, Programa Parcial de Desarrollo
Santa Fe, Delegación Cuajimalpa, Distrito Federal, México 05349
ROCKETFISH is a trademark of BBY Solutions, Inc. Registered in some countries. All other products and brand names are
trademarks of their respective owners.
6907-002013<00> 10-0361
Loading...