Rivera Primo PC-2000 User Manual

The PC-2000 CLUTCH HUB PULLER for tapered shaft Pro Clutch applications consists of 4 pieces. The bolt plate, the bolt, and 2 adaptors. The long adaptor with the deep hole is use with for 4-speed (coil spring clutch) short shaft applications, the short adaptor is for use with for long shaft 5 speed (diaphragm spring clutch).

PC-2000 INSTRUCTIONS

Loosen & remove the 4 shouldered nuts as shown. Remove the clips, retainer, diaphragm spring and pressure plate as pictured.

Remove the clutch hub nut (left hand threads) from the transmission mainshaft.

Place the long adaptor with recess for the clutch rod on the mainshaft as shown.

Install the PC-2000 onto the transmission mainshaft as shown. Tighten shouldered nuts snug, making sure that the plate is flat on the 4 clutch hub studs.

Give it a sharp tap with a medium weight steel hammer (wear safety goggles).

Turn the center bolt clockwise until it contacts the adaptor on the mainshaft, then another 1/4-1/2 turn.

3. Mount the puller plate on the clutch hub studs using the 4 shouldered nuts. Make sure the plate is seated evenly on all 4 studs. Make sure that all 4 nuts are tight.

4. Turn the center bolt until it contacts the adaptor positioned on the mainshaft. Slowly turn the bolt clockwise 1/4-to-1/2 turn putting pressure on the plate. Give the bolt a sharp tap with a medium weight steel hammer. If needed, go another 1/4 turn and repeat the tap.

RIVERA

Engineering Inc.

12450 Whittier Blvd, Whittier, CA 90602

(562) 907-2600 fax (562) 907-2606 www.riveraengineering.com

rear view

front view

1. Remove the 4 shouldered nuts, retainer, diaphragm spring, & pressure plate.

2. Remove the left hand thread

clutch hub nut.

3. Install the adaptor on the

end of the trans mainshaft.

apply anti seize to stud theads

prior to installing shoulder nuts