Rivera Primo Equalizer Motor Plate User Manual
Rivera Primo’s EQUALIZER MOTOR PLATE is designed to couple the motor and transmission together when using
an open primary belt drive system. Manufactured in the USA from virgin aluminum, the Equalizer will outlast your
motorcycle. It bolts directly to Rivera Primo’s alternator cover (# 2014-0002) and bearing support (#PP-103).
When installing the plate as a unit with the alternator cover & bearing support it is recommended that threadlock be
used with the appropriate bolts. If you’re using studs and locknuts also use threadlock. Ensure that all components are
correctly aligned before using threadlock.
An inch or more of adjustment is available for adjusting belt tension & and transmission alignment. Two thick washers
are supplied to protect the slot indents. The two studs supplied with the kit are intended for use in the two holes in the
left side of the transmission case. Remove the OEM studs and replace them with these. The idler is optional.
For all further information contact Rivera Primo at (562) 907-2600.
12450 Whittier Blvd., Whittier, CA 90602
Tel: (562) 907-2600 Fax: (562) 907-2606
www.riveraprimoinc.com
PP-130 / PP-170
INST
INST
ALLA
ALLA
TION INTRUCTIONS
TION INTRUCTIONS
for
for
EQUALIZER
EQUALIZER
MOTOR PLATE
MOTOR PLATE
HOME OF PRIMO®BELT DRIVES
QUALITY & PERFORMANCE SINCE 1973
Loading...