REVELL NANO Hexagon User Manual

2

AA

AA

AA

AA

CHARGING

INSTALL THE BATTERIES INTO THE CONTROLLER

1. Plug charger into computer or USB charge adapter. The LED on the
charger will turn on.

2. Make sure that the On/Off switch on the Nano Hexagon is off and
connect charger. The LED on the charger will turn off while the
battery is charging.

3. Typical charge time is 40 minutes. LED will turn on when the battery
is charged.

• NEVER leave the battery unattended while charging.

• DO NOT allow the USB port to power down while the
charger is connected to the battery.

• ALWAYS unplug the charger from the USB port and
the Nano Hexagon when charging is complete.

Remove the battery cover screw and the battery cover.
Install 2 AA batteries and replace the cover.

3

MOTOR ARMING

1. Turn on . Make sure the left
stick is at its lowest position.

The motors are now armed and your Nano Hexagon is ready to fly.

2. Place the Nano Hexagon on a level surface.

3. Turn on the Nano Hexagon and wait for the controller to beep twice.

4. Advance the left stick to its highest position and wait for the controller to beep once.

5. Return the left stick to its lowest position and wait for the controller to beep one more time.

4

BASIC FLYING

2. Moving the right stick in any
direction will make the Nano
Hexagon fly in the same direction.

3. The Nano Hexagon will rotate its
nose left or right when the left
stick is moved to the left or right.

1. To take off, SLOWLY advance the left stick until
your Nano Hexagon lifts off.

Please keep in mind that when the front of the model is pointed toward you, moving the sticks on the
controller will appear to move the Nano Hexagon in the opposite direction. To avoid confusion, try to
imagine that you are in the middle of your Nano Hexagon when flying.