Renesas E2 User Manual

RENESAS TOOL NEWS

R20TS0670EJ0100

[Upgrade to revision]

E2 emulator Self Check Program V.1.02.00

Rev.1.00

Feb.01, 2021

Outline

The self-check program for E2 emulator (E2 SCP) has been updated from V.1.01.00 to V.1.02.00.

1. Version to be updated

The target of this update is the E2 emulator (model name: RTE0T00020KCE00000R) with product version
"D" or later. The self-check program V.1.02.00 can also be used for products whose product version is "C" or
earlier.

[confirmation method of the product version of the E2 emulator]

The product version of the E2 emulator is the last digit of the serial number displayed in the following location.

・Sticker on the back of the E2 emulator product
・Interior labels attached to packing boxes
・Start screen when E2 SCP is connected

* The red line is the product version.

Figure 1. Example of product version

R20TS0670EJ0100 Rev.1.00 Page 1 of 3
Feb.01, 2021

RENESAS TOOL NEWS

2. Version upgrade contents

2.1 Functional improvement

Since the self-check circuit was partially changed in the product version D or later of the E2 emulator, the
self-check program was updated. There are no additional functions or changes in usage. For the usage of
the self-check program, refer to Appendix A of the E2 emulator RTE0T00020KCE00000R User's Manual.

3. Update method

There are two ways to update the Self Check Program for E2 Emulator (E2 SCP) : by downloading the
standalone installer of E2 SCP from the E2 Emulator web page, or by installing it from the Integrated
Development Environment CS+ for CC.

1) E2 SCP standalone installer

Download the installer from following web page below.

(The installer will be available from February 5.)

E2 emulator [RTE0T00020KCE00000R] | Renesas

2) Install the emulator utility using the Integrated Development Environment CS+ for CC installer.

(To be supported in the next CS+ update (date to be determined))

R20TS0670EJ0100 Rev.1.00 Page 2 of 3
Feb.01, 2021