Remington D-3200N User Manual
Use & Care Guide
®
ProAir®Ceramic
Model D-3200N
Please Read
Prior to Use
IMPORTANT SAFEGUARDS
SAVE THESE
INSTRUCTIONS
WARNING
To reduce the risk of burns, electrocution,
fire, or injury to persons:
1. An appliance should never be left
unattended when plugged in.
2. Close supervision is necessary when this
appliance is used by, on, or near children
or invalids.
3. Use this appliance only for its intended
use as described in this manual. Do not
use attachments not recommended
by Remington.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged, or dropped into water. Return the
appliance to Remington Customer Service
for repair or replacement.
5. Keep the cord away from heated surfaces.
Do not wrap the cord around the appliance.
6.
Never block the air openings of the appliance
or place it on a soft surface, such as
a bed or couch, where the air openings may
be blocked. Keep the air openings free of
lint, hair, etc.
7. Never use while sleeping.
8. Never drop or insert any object into an
opening on the dryer.
9. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
When using electrical appliances, especially
when children are present, basic safety
precautions should always be followed,
including the following.
READ ALL INSTRUCTIONS
BEFORE USING.
DANGER
KEEP AWAY FROM WATER
As with most electrical appliances, electrical
parts are electrically live even when the switch
is off.
To reduce the risk of electric shock:
1. Always unplug hair dryer immediately
after using.
2. Do not use while bathing.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place or drop into water or
other liquid.
5. If an appliance falls into water, “unplug it”
immediately.
Do not reach into the water.
10. Do not direct hot air toward eyes or other
heat sensitive areas.
11. Attachments may be hot during use. Allow
to cool before handling.
12. Do not place appliance on any surface while
it is operating.
13. While using the appliance, keep your hair
out of it– keep your hair away from the
air inlets.
14. Do not use in countries with 220/240 volt
electrical systems–use only with 110/120
volt electrical systems.
15. Do not operate with a voltage converter.
16. Connect this appliance to a properly
grounded outlet only.
17. Do not use an extension cord with this
appliance.
18. Household use only.
Operating Instructions
2. Should the ALCI safety device trip (i.e., reset
button pop out) during use, press the reset
button. Should the dryer fail to reset, return
the dryer to Remington Customer Service for
examination and repair or replacement.
Never operate this appliance if it has been
dropped in water; return it to Remington
Customer Service for examination and repair
or replacement.
3. The dryer is designed to work on ordinary
household current only, 125 volts A.C.,
60 Hz. It is not intended for commercial use.
4. This appliance is equipped with an automatic
thermal limiter which will cycle off when
overheated and come back on when cooled
down. If the unit cycles off, unplug the cord
for several minutes before restarting.
5. This appliance has a polarized plug (one
blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
1. This hair dryer is provided with an
appliance leakage circuit interrupter
(ALCI) safety device built into the plug.
This device is designed to make the
unit inoperable under some abnormal
conditions, such as accidental immersion in water. The ALCI safety device
is equipped with a test button so that
its operation can be checked.
This unit should be tested before each
use to confirm that the safety device is
operational.
TO TEST:
After plugging in your hair dryer:
A. Press the reset button on the
ALCI device.
B. Press the test button. The reset button
will pop out. This verifies that the
safety device is operating properly.
C. Press the reset button to reactivate
your ALCI safety device.
D. Your hair dryer is now ready for use.
Note: This unit may automatically trip
when unplugged. If so, unit must be
reset after it is plugged in. After
following the above testing procedure,
should the indicator device not function
properly, return the dryer to Remington
Customer Service for examination and
repair or replacement.
Loading...