Raymarine St290 User Manual
ST290 Graphic Display - quick reference guide
ST290 Graphic Display Alarm pages
Alarm pages enable you to set alarm modes & thresholds
You can use alarm pages to:
Set the operating mode of each Alarm, either OFF, ON or for operation with
an Auxilliary (external) alarm unit.
Set the threshold of each Alarm, to define when the Alarm will operate.
Note: Where examples are required, this guide uses the High Apparent Wind Angle Alarm. The principles are valid for all Alarms.
How to see Alarm pages
1. Enter the ALARMS chapter
2. Select the Alarm page you want
SPEED
LOW
alarm
HI SEA
TEMP
alarm
LO SEA
TEMP
alarm
SHALLOW
alarm
DEEP
alarm
SHALL.
ANCHOR
alarm
SPEED
LOW
alarm
TWS
HIGH
alarm
TWS
LOW
alarm
TWA
LOW
alarm
1 s
All Alarm pages display
Anchor Alarm pages display
Note: This illustration shows the Alarm pages available in an
ST290 Full Profile. If a different profile is selected, some Alarm
pages may not be available.
TWA
HIGH
alarm
AWS
LOW
alarm
AWS
HIGH
alarm
DEEP
ANCHOR
alarm
OFF
COURSE
alarm
AWA
HIGH
alarm
AWA
LOW
alarm
D6298-1
ST290 Graphic Display Alarm pages
How to set the Alarm mode
1.
3.
Switch the alarm OFF Switch the alarm ON
How to adjust Alarm levels
1.
2.
Use
Alarm you want to set up
to select the
Set the alarm to operate
with an Auxilliary alarm unit
Auxilliary alarm
indicator
2.
Use
Alarm you want to set up
to select the
3.
Hold down
to enter setup mode.
for 1 s
5.
Hold down
to leave setup mode and
save the alarm value you
have set.
Document number: 86084-1
Use with: ST290 Instrument System Owner’s Handbook
Date: 15 May 2003
for 1 s
4.
or Use
to set the alarm value
you want
6.
Repeat steps 2 to 5 for each Alarm you
want to set up.
D6299-1
Loading...