Pitney Bowes Relay 1000 Quick Install Manual

Document Inserting System

Quick Install Guide

International English Edition

SV63177 Rev. B

February 1, 2016

Shipping & Mailing

Inserter

Relay 1000

™

FCC Compliance

This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
interference to radio communications. Operation of this equipment in a
residential area is likely to cause interference, in which case the user will
be required to correct the interference at his own expense. Use only a
shielded interface cable to operate this equipment with a printer or other
peripheral device.

CAUTION: Changes or modications to this equipment not expressly

approved by the party responsible for compliance (Pitney Bowes) could
void the user’s authority to operate the equipment.

SV63177 Rev. B February 1, 2016

©2005, 2016 Pitney Bowes Inc. All rights reserved. This guide may not
be reproduced in whole or in part in any fashion or stored in a retrieval
system of any type or transmitted by any means, electronically or
mechanically, without the express, written permission of Pitney Bowes.

We have made every reasonable effort to ensure the accuracy and
usefulness of this manual; however, we cannot assume responsibility
for errors or omissions or liability for the misuse or misapplication of our
products.

Due to our continuing program of product improvement, equipment and

material specications as well as performance features are subject to

change without notice. Your inserter system may not have some of the
features described in this book.

E-Z Seal is a registered trademark of Pitney Bowes Inc. ENERGY STAR
is a registered trademark of the United States Environmental Protection
Agency.

It is certified that this system complies with all applicable
Directives of the European Union.

Relay 1000 Quick Install Guide

1SV63177 RevB

Follow the instructions in this guide to get your Relay 1000 system setup
and running in the shortest possible time. Included in this guide are
instruction for the following:

• Unpack • Load envelopes

• Set in place • Load sheets

• Connect • Setup

• Fill the moistener • Run a test piece

IMPORTANT: If you purchased the optional second sheet feeder, unpack
it and position it on the desktop BEFORE you follow these instructions.

Relay 1000 Quick Install Guide

2 SV63177 RevB

Step 1: Unpack

1. Lift out the following
accessories and put them to
one side:

• Test paper and envelopes

• Bottle of E-Z seal®

• Power Cord

2. Remove the cardboard and
foam packing.

Relay 1000 Quick Install Guide

3SV63177 RevB

Step 2: Set in Place

1. Lift the inserter by
its handles and
place it on a flat
surface.

.

SAFETY NOTICE!

• Lift the inserter only by its lifting handles.

• Lift correctly (bend knees and keep back
straight).

• The inserter weighs about 38 lb (17.5 kg). It
is recommended you get help to lift it.

2. If you have the
optional 2nd sheet
feeder, position the
inserter onto that
feeder now.