Philips Rwhf, Rphf, Rchf User Manual
Philips Lighting North America Corporation
Philips Lighting Canada Ltd.
9140050346 February 2016
RCHF, RPHF, RWHF
Hazardous Location Fixtures
INSTALLATION INSTRUCTIONS
FOR MOUNTING ACCESSORIES
NOTE: Outlet box threads must be lubricated to
prevent galling. Lightly lubricate with Killark
“LUBT” lubricant or equivalent, for ease of future
maintenance.
NOTE: Refer to marking on fixture nameplate for
required supply wire temperature rating. Fixture
mount must be grounded. Connect the ground wire
to the green screw provided inside the mounts
(except wall bracket mount)
CEILING MOUNT (RCHF)
(See Figure 1)
Install ceiling mount on support surface by using
the (4) external mounting holes. Remove terminal
block from the mount and connect electrically as
described under Pendant Mount. Plug unused
conduit entries with closeup plugs provided.
PENDANT MOUNT (RPHF)
(See Figure 2)
Install pendant mount to conduit or use optional
(SEA) swivel elbow arm and secure with locking
set screw. Remove terminal block from the mount
by loosening the (2) mounting screws. Connect the
ground wire to the green screw. Connect supply
wires to the terminal block. Reinstall terminal block
and securely tighten it in place.
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
www.philips.com/luminaires
281 Hillmount Road,
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
Philips Lighting North America Corporation
Philips Lighting Canada Ltd.
9140050346 February 2016
WALL BRACKET MOUNT (RWHF)
(See Figure 3)
Install wall bracket mount on support surface, using
the (2) external mounting holes. Unscrew and
remove inspection cap. Pull out Black (line), White
(common / neutral), and Green (ground) wires
through the inspection hole (wires will extend out
about 6 inches) and connect to supply wires using
wire nuts. Push the wires back in and replace the
cap. Plug unused conduit openings with closeup
plugs provided.
INSTALLATION INSTRUCTIONS
FOR LIGHTING FIXTURE
SAVE THESE INSTRUCTIONS
IMPORTANT:
(1): See fixture nameplate for specific hazardous
location suitability and specific supply wire
(minimum temperature rating).
(2): Verify the ground continuity in the electrical
system.
(3): Do not operate this fixture if the ambient
temperature exceeds the rating shown on the
nameplate.
WARNING: Turn OFF the supplying circuit
before beginning installation, or performing any
maintenance including relamping.
WARNING: Do not operate this fixture on an
ungrounded system.
NOTE: All installations must comply with
applicable local regulations and/or the National
Electrical Code.
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
www.philips.com/luminaires
281 Hillmount Road,
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
Loading...