Philips MG7750 User Manual

- Never operate this product if it has
a damaged power cord, if it is not
working properly, if it has been
dropped or damaged, or dropped into
water while plugged in. For assistance
call 1-800-243-3050.

- Product can be rinsed under running
tap water. Never use water hotter than
175°F (80°C). Do not charge or operate
the product until fully dried.

- Keep the product, power cord and
any attachments away from heated
surfaces.

- Never drop or insert any object into
any opening.

- Do not use the adapter in or near a
power outlet that contains an electric
air freshener to prevent damage to the
power cord.

- Do not operate, charge, clean or
plug in product outdoors or operate
where aerosol (spray) products are
being used or where oxygen is being
administered.

- Always check cutters, cutting unit and
guards before using the product. Do not
use the product if cutters, cutting unit
or guards are damaged, as injury may
occur.

- Always attach power cord to product
rst, then to power outlet. Be certain
plug is inserted rmly into product
up to mark indicated on plug. To
disconnect turn product o then
remove power cord from outlet.

- Keep the power cord dry at all times.
Do not handle with wet hands.

- Never put the product in direct
sunlight or store at a temperature
above 140°F (60°C).

- To prevent possible damage to the
power cord, do not wrap power cord
around the product.

- This product is for use on human hair
only. Do not use the product for any
other purpose.

- Always store the product, attachments
and power cord in a moisture­free area. Make sure the cord is
disconnected from the product.

- Do not attempt to open the product
to remove/replace the built-in
rechargeable battery.

- Only use the power cord and other
accessories supplied with the product.

IMPORTANT
SAFETY
INSTRUCTIONS

When using an electric product, basic
precautions should always be followed,
including the following:

Read all instructions before using this
product.

DANGER

To reduce the risk of electric shock:

- Do not reach for a corded product
that has fallen into water. Unplug
immediately.

- Use product only in dry condition.
Do not use while bathing or in a
shower.

- Do not submerge product in water.

- Do not place or store the product
where it can fall or be pulled into a
tub or sink. Do not place or drop the
product in water or other liquid.

- Always unplug this product from the
electrical outlet immediately after use,
except when product is (re)charging.

- Unplug and remove power supply
cord from this product before
cleaning.

- The batteries used in this product may
present a re or chemical burn hazard
if mistreated. Do not disassemble,
heat above 100°C (212°F) or incinerate.

WARNING

To reduce the risk of burns, re, electric
shock, or injury to persons:

- Close supervision is required
when this product is used by, on,
or near children,

or persons with
limited physical, sensory, or mental
capabilities or invalids.

- Use this product only for its intended
use as described in this manual. Do
not use attachments not specied by
Philips North America LLC.

SAVE THESE
INSTRUCTIONS

IMPORTANT: The power plug contains a

transformer. Do not cut o the power plug
to replace it with another plug as this will
cause a hazardous condition.

Introduction

Congratulations on your purchase and
welcome to Philips Norelco!
To fully benet from the support that
Philips Norelco oers, register your
product at www.norelco.com/register.

5/64in

2mm

3/16in

5mm

3/64in

1mm

1/8in
3mm

9/32in

7mm

5/32in

4mm

21/32in

16mm

15/32in

12mm

3/8in
9mm

2

9

18

20

11

10

17

19

12

13

14

3

4

5

6

7

8

16

15

1

5/32in – 3/8in

4-9mm

21

22

3/16in

5mm

1/8in
3mm

24

23

1

General description (Fig. 1)

1

Extra-wide hair trimmer
2 Precision trimmer
3 Nose trimmer
4 Precision shaver
5 Full-size hair trimmer
6 On/o button
7 Battery status indicator
8 Socket for small plug
9 Stubble guard 3/64in. (1mm)
10 Stubble guard 5/64in. (2mm)
11 Beard guard 1/8in. (3mm)

www.philips.com

MG7750

BC

4222.002.8788.5

Manufactured for:
Philips Personal Health
a division of Philips North America LLC
P.O. Box 10313, Stamford, CT 06904

This symbol on the product’s nameplate means
it is listed by Underwriters’ Laboratories, Inc.

Norelco is a registered trademark of
Philips North America LLC.

PHILIPS and Philips shield are registered trademarks of
Koninklijke Philips N.V.

©2017 Philips North America LLC.
All rights reserved.

ENGLISH

12 Beard guard 3/16in. (5mm)
13 Beard guard 9/32in. (7mm)
14 Eyebrow guard 1/4in. (6mm)
15 Power plug
16 Small plug
17 Hair guard 5/32in. (4mm)
18 Hair guard 3/8in. (9mm)
19 Hair guard 15/32in. (12mm)
20 Hair guard 21/32in. (16mm)
21

Fading hair guard 5/32in.-3/8in. (4-9mm)

22

Fading hair guard 5/32in.-3/8in. (4-9mm)
23 Body guard 1/8in. (3mm)
24 Body guard 3/16in. (5mm)
Not shown: cleaning brush, pouch

This symbol indicates that the
product can be rinsed under
running tap water.

432

10

1

2

98

6

2

1

5

1

2

7

1311 12

161514

1917 18

25

28

23

26

24

27

222120

Charging

Battery status indications

- When the battery is almost empty,
the battery status indicator lights up
orange (Fig. 2).

- When the product is charging, the
battery status indicator ashes white
slowly (Fig. 3).

- During quick charge, the battery status
indicator ashes white quickly. After
approx. 5 minutes of charging, the
battery indicator ashes white slowly.
The product now contains enough
power for one cordless trimming session.

- When the battery is fully charged, the
battery status indicator lights up white
continuously (Fig. 4).

Note: After approx. 30 minutes, the light
goes out automatically.

Charging

Charge the product before rst use and
when the display indicates that the battery
is almost empty. When the product has
charged for 3 hours, it has a cordless
operating time of up to 5 hours.

- Charging, recharging or using the product
at temperatures below 40°F (4,5°C) or
higher than 95°F (35°C) adversely aects
the lifespan of the battery.

- If the product is subjected to a major
change in temperature, pressure or
humidity, let the product acclimatize
for 30 minutes before use.

1 Make sure the product is turned o.
2 Insert the small plug into the product

and put the power plug in any 120V AC
outlet (Fig. 5).

3 After charging, remove the power plug

from the wall outlet and pull the small
plug out of the product.

Note: An adapter plug may be necessary
for cord usage in some foreign countries.
Use an attachment plug adapter of the
proper conguration for power outlet.

Quick charge

After approx 5 minutes charging,
the product contains enough power
for one cordless trimming session.

Using the product

Always check the product and all accessories
before using. Do not use the product or any
accessory if it is damaged, as this may cause
injury. Always replace a damaged part with
one of the original type.

Note: This product can be used without
cord or directly from the power outlet.

Note: Switch o and clean the product
and attachments after each use.

- Use this product for its intended
household use as described in this
manual.

- For hygienic reasons, the product
should only be used by one person.

- Trimming is easier when the skin and
hair are dry.

- Be careful when trimming without a
guard as when the product is turn on it
will trim every hair it touches.

Detaching and attaching cutting elements

1

To detach a cutting element, push
upwards against the teeth of the cutting
element and take it o the handle (Fig. 6).

2 To attach a cutting element, insert

the lug of the cutting element into the
guiding slot at the front and push the
back of the cutting element onto the
product (`click`) (Fig. 7).

Detaching the precision shaver and
nose trimmer

1 Place your nger on the arrow at the

back of the attachment and push it o
the handle in the direction of the arrow
(Fig. 8).

Attaching and detaching guards

1 To attach any type of guard onto a

cutting element, slide the front part of
the guard onto the teeth of the cutting
element. Then push down the center of
the guard with your ngers or the palm
of your hand. (`click`) (Fig. 9).

2 To detach any type of guard from the

cutting element, carefully pull its back
part o the product and then slide it o
the cutting element (Fig. 10).

Note: When trimming for the rst time,
start by using the guard with the maximum
trimming length setting to familiarize
yourself with the product.

Switching the product on and o

1 Press the on/o button once to turn the

product on or o (Fig. 11).

Attachments for use on beard

Full-size hair trimmer

Use the full-size hair trimmer without a
guard to trim hair close to the skin (to a
length of 1/32in./0.5mm). or to create
clean lines around your beard, neck and
sideburns.
1 To trim hair close to the skin, place the

at side of the cutting element against
your skin and make strokes against the
direction of hair growth (Fig. 12).

2 For contouring, hold the cutting

element perpendicular to the skin and
move it upwards or downwards with
gentle pressure (Fig. 13).

Beard guards

Attach a beard guard to the full-size hair
trimmer to trim your beard and moustache
evenly. The product comes with 5 beard
guards. The hair length settings are
indicated on the guards. The settings
correspond to the remaining hair length
after trimming.