HF3510
User manual
Manuel d’utilisation
IMPORTANT SAFETY
INSTRUCTIONS
WARNING – To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
1. Never use the appliance if the lamp housing is damaged, broken or
missing.
2. Heed all warnings.
3. Do not look directly at lighted lamp.
4. If the appliance, power supply cord or cord has been damaged in any
way, liquid has spilled or objects have fallen into the appliance, the
appliance has been exposed to rain or moisture, does not operate
normally or has been dropped or damaged, it should not be operated.
5. Read this user manual carefully before you use the appliance and
save it for future reference.
6. Water and electricity are a dangerous combination. Do not use this
appliance in wet surroundings (e.g. in the bathroom or near a shower
or swimming pool).
7. Make sure the adapter does not get wet.
8. Do not let water run into the appliance or spill water onto the
appliance (see below).
9. The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
10. Only use the original adapter. If the adapter or any of the other
accessories is damaged, do not use. Call 1-866-832-4361 for assistance.
11. Do not use the adapter in or near a power outlet that contains an electric air freshener to
prevent damage to the adapter.
12. This appliance is for indoor use only.
13. Make sure the vents on the appliance remain open during use.
14. Protect the power cord from being walked on or pinched,
particularly at plugs, outlet and point where they exit from lamp.
15. The appliance has no on/off switch. To disconnect the appliance
from the power source, remove the plug from the wall outlet.
SAVE THESE INSTRUCTIONS
3
General
Buttons
First use
Menu
What’s in the box
Important information
Introduction
Icon explanation
Overview
Clock time
Wake-up prole
Lamp on/off button
6
7
10
FM
10
11
SNOOZE
Radio on/off button
Alarm on/off button
Snooze
16
17
18
19
Display contrast
20
12
Fall asleep button
21
Extra options
13
Demonstration mode
22
Wake-up sound
Adjusting clock time
4
14
15
Storage
23
Disposal
Assistance
45-Day Money-Back Guarantee
Full Two-Year Warranty
Troubleshooting
23
23
24
24
25
5
What’s in the box
6
Important information
Warning
– Check if the voltage indicated on the adapter corresponds to the local voltage before you
connect the appliance.
– This adapter transforms 100-240 volts to a safe, low voltage of less than 24 volts.
– The appliance is suitable for a voltage of 120V AC and a frequency of 50/60 Hz.
– Close supervision is necessary when this appliance is used by, or near children or invalids.
– Children should be supervised to ensure that they do not play with the appliance.
7
Caution
– Do not drop the appliance on the oor, hit it hard or expose it to other heavy shocks.
– Place the appliance on a stable, level and non-slippery surface.
– Do not use the appliance at room temperatures lower than 50°F/ 10°C or higher than
95°F/35°C.
– Consult your doctor before you start using the appliance if you have suffered from or are
suffering from serious depression.
– Do not use this appliance as a means to reduce your hours of sleep. The purpose of this
appliance is to help you wake up more easily. It does not diminish your need for sleep.
– This appliance is only intended for household use, including similar use in hotels.
Do not use attachments not recommended by Philips North America LLC (USA) or
Philips Electronics Ltd (Canada).
General
– This appliance allows you to choose the light intensity level you want to wake up to.
– If you often wake up too early or with a headache, reduce the light intensity level.
– If you share a bedroom with someone else, this person may unintentionally wake up from the
light of the appliance, even though this person is further removed from the appliance. This is the
result of differences in light sensitivity between people.
– The power consumption of the appliance is lowest if the radio and the lamp are turned off.
8
FCC Information
– This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
– Consult the dealer or an experienced radio/TV technician for help.
– This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
9
Introduction
– This Class B digital apparatus complies with Canadian ICES-003 and ICES-005.
Congratulations on your purchase and welcome to Philips! To fully benet from the support that
Philips offers, register your product at www.philips.com/welcome.
The Philips Wake-up Light helps you wake up more pleasantly. Thirty minutes before the set wake up
time, the light intensity of the lamp gradually increases to the set level. The light gently prepares your
body for waking up at the set time. To make waking up an even more pleasant experience, you can
use natural wake-up sounds or the FM radio to wake up to.
The effects of the Wake-up Light
The Philips Wake-up Light gently prepares your body for waking up during the last 30 minutes of
sleep. In the early morning hours our eyes are more sensitive to light than when we are awake.
During that period the relatively low light levels of a simulated natural sunrise prepare our body
for waking up and getting alert. People who use the Wake-up Light wake up more easily, have a
better overall mood in the morning and feel more energetic. Because the sensitivity to light differs
per person, you can set the light intensity of your Wake-up Light to a level that matches your light
sensitivity for an optimal start of the day.
For more information about the Wake-up Light, see www.philips.com.
Icon explanation
Wake-up prole
Wake-up sound Fall asleep
Clock time Natural sounds
Display contrast Radio
Lamp
10
FM
FM radio
Overview
FM
Display
Menu-buttons - press to activate
Navigating through the menu
Press the MENU button
to enter the menu
Press the + or – button
to select a menu setting
Press SELECT to confirm
1 2 3
Note:
To exit the menu, either press the MENU button or wait for 30 seconds.
11
16-20in/
40-50cm
Place the Wake-up Light 16-20in/40-50cm from your head, for example on a bedside table.
First use - placing the Wake-up light
First use - setting the clock time
You have to set the clock time when you plug in the appliance for the rst time and when there has
been a power failure.
1
4
2
5
3
12
Setting your wake-up prole
When you set your wake-up prole, you set the wake-up time (steps 1 – 6), the light intensity
(steps 7 and 8) and the sound level (steps 9 and 10) you want to wake up to.
1
5
9
OFF
20
Note:
Because the sensitivity to light differs per person, you may have to experiment with different settings
for a few days to nd your optimal level.
2
6
10
3
7
OFF
20
4
8
13
Setting your wake-up sound
You can use natural wake-up sounds or the FM radio as a wake-up sound. The Wake-up Light has
three built-in natural sounds.
1
4
4
2
5
5
3
6
6
14
Adjusting the clock time
To set the clock time, choose between a 12-hour and a 24-hour clock and then adjust the time.
1
5
2
6
3
12H / 24H
7 8
4
15
Switching the lamp on/off
Press the lamp on/off button to switch on the lamp and use it as a bedside lamp. You can adjust the
light intensity by pressing the + and – buttons. To switch off the lamp, press the lamp on/off button
again.
1 3
2
1
20
16
FM
Switching the FM radio on/off
Press the FM on/off button to switch on the FM radio.
1
2
FM
1X
3
4
1
FM / USB FM / USB
Note:
To scan radio frequencies automatically, press and hold the menu - or + button for approx.
2 seconds.
20
17
Switching the alarm on/off
Press the alarm button if you want to switch the alarm on or off. The corresponding icon appears on
the display when you switch on the alarm. It dissappears when you switch off the alarm. When you
switch on the alarm, the hour indication starts to ash. If necessary, you can now adjust the alarm
time.
1
4
Note:
If you want to adjust the light level or volume to wake up to, you have to use the menu.
See chapter ‘Setting your wake-up prole’.
2
5
2
18
SNOOZE
When the alarm sound is played at the set time, you can press the SNOOZE button to snooze for a
while. The lamp stays on, but the alarm sound stops. After 9 minutes, the alarm sound is played again
automatically.
Snoozing
1
9 min.
Note:
- The alarm icon ashes on the display when the alarm is snoozed.
- If you press either the ‘FM’ button, the ‘Fall asleep’ button or the ‘MENU’ button while the alarm
sound is playing, the alarm stops and is not snoozed. If you press the ‘Alarm’ button while the
alarm sound is playing, you disable the alarm function. The alarm icon disappears from the display.
To reactivate alarm function, press the ‘Alarm’ button again.
19
Setting the display contrast
You can adjust the display contrast from level 1 to level 4. Choose a level that is optimal for you to
see the display at night. Press the display contrast button several times to adjust the display contrast
level.
1
2
1x 4x
20
Fall asleep
Press the fall asleep button when you want the light and/or the sound of the Wake-up Light to stay on
and dim gradually during a set period of time (5 to 60 minutes) before you go to sleep. The lamp and/or
sound switch off automatically after the set time.
1. Press the fall asleep button to switch on the fall asleep function.
2. The set fall asleep time appears on the display.
3. Press the + or – button to adjust the time (5 to 60 minutes).
To switch off the fall asleep function, press the fall asleep button again. The fall asleep icon disappears
from the display.
1
Note:
If you press the fall asleep button when neither the lamp nor the FM function is on, the lamp goes on
and will dim gradually.
2
60 min
5
3
21
Demonstration mode
If you want a quick demonstration (90 seconds) of the gradually increasing light intensity and sound
level, switch on the test function of the appliance.
1. Press and hold the alarm button for at least 3 seconds.
2. The appliance starts the demonstration of the alarm.
3. To switch off the demonstration, press and hold the previously pressed alarm button for
3 seconds again.
1
> 3 sec.
2
90 sec.
3
> 3 sec.
Audio feedback
When you press a menu button, you hear a click. If you do not want to hear clicks when you press
a button, press and hold the FM button for 5 seconds to switch off the audio feedback. You hear
one click as a conrmation. To activate, press and hold the FM button again. You hear two clicks to
conrm that the audio feedback is activated.
Button backlight
The menu buttons have a backlight to help you to nd the buttons. If you move your ngers close to
the buttons, the backlight lights up. If you don’t press the button, the backlight goes out after a few
seconds.
22
Storage
– Clean the appliance with a soft cloth.
– If the appliance will not be used for an extended period of time, remove the power cord from
the wall outlet and store the appliance in a safe, dry location where it will not be crushed,
banged, or subject to damage.
– Do not wrap the power cord around the appliance when storing it.
– This appliance has no other user-serviceable parts. For assistance, call 1-866-832-4361.
Disposal
Your product is designed and manufactured with high quality materials and components, which can
be recycled and reused. For recycling information, please contact your local waste management
facilities or visit www.recycle.philips.com
Assistance
www.philips.com/support
For assistance visit our website: www.philips.com/support or call toll free: 1-866-832-4361.
23
Loading...