Philips HD7811, HD7894, HD7862, HD7811/72, HD7811/92 Service Manual

Coffee Maker Senseo

HD7811/94

Philips Consumer Lifestyle

Service Manual

PRODUCT INFORMATION

- This product meets the requirements regarding
interference suppression on radio and TV.

- After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.

TECHNICAL INFORMATION

- Voltage : 120 V

- Frequency : 60 Hz

- Power consumption : 1450 W

- Standby power consumption : < 1W

- Contents reservoir : 750 cc

- Colour setting : Deep Red

- SAP coding : HD7811/94

OPTIONAL (accessories)

- XL watertank (10 Cups)
Commercial type number HD7982
Service code : 4222 259 20100

L

Pump

N

Water level
Sensor

M

CONTROL

PCB

Push buttons

Temp.
Sensor

TCO

Boiler

Fuse

Fuse

Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright reserved Subject to modification

10/05

DISASSEMBLY- AND RE-ASSEMBLY ADVISE

Disassembly information

HD7811/94

To remove the brew chamber lid cover handle as follows:

- Place the screwdriver on the
positions (see picture 1) and
lift the cover over the snap
locks on both positions.

picture 1

- The cover lid can now be lifted
up a little and to remove the
complete cover including lever
and push rod squeeze strongly
with two fingers both legs of
the push rod (see picture 2)
to each other, so that the two
pins will get out of the hinge
position on the brew chamber.

- To remove lever from lid cover, take a screwdriver and bend
carefully the two lips/ribs in the lid cover outwards and
push the lever with force out of the hinge.

- Reassemble follow steps backwards, without using a
screwdriver.

To remove the back cover handle as follows:

- Remove valve outlet.

- Start at the upper side of the back cover and stick a
screwdriver into the 2 snap locks positions and gently pull
the back cover from the appliance so that a little chink
between back cover and brew chamber becomes visible.

- Put the screwdriver in to the 4 rectangular holes (snap
locks) at the back and gently pull the screwdriver such away
that the lips of the snap locks are bent outwards.

- If all clicks positions are loose, it is possible to remove the
back cover.

- Reassemble follow steps backwards.

picture 2

Removing Brew chamber head handle as follows:

- Disassemble back cover!

- Place the appliance such a way that you are looking at the
boiler.

- First remove the boiler from the snap lock position of the
brew chamber.

- To remove the brew chamber, use your both thumbs
(see picture 3) and push
strongly with a little distortion
(rotation) until the brew
chamber comes loose.

- Reassemble follow above steps
backwards.

To reach the components placed on the base handle as
follows:

- First remove back cover, brew chamber and 3-way valve.

- Remove both Torx T15 screws see exploded view in the near
of position A.

- Bend the 2 click snap locks with a screwdriver (see base),
and the housing can now be removed.

- To remove the rest of the housing unlock the last 4 snap
locks at the base and gently pull of the front cover.

- To reassemble follow above steps backwards.

picture 3

2-6