Brilliance FC6688, FC6687, FC6686, FC6685
3
ENGLISH 4
ESPAÑOL 10
FC6688, 6687, 6686, 6666
4 ENGLISH
Important
Read these instructions carefully and look at the illustrations before you start using the appliance.
Never use the appliance on wet floors, or floors on which ashes or inflammable or explosive liquids are present.
Make sure that the handstick is in upright position (i.e. that the appliance is switched off) before connecting it to the mains.
Always remove the mains plug from the wall socket before turning the polisher upside down, e.g. to remove or attach the brushes or polishing discs.
Make sure that the mains cord does not end up under the appliance while it is running. Prevent hands, feet, hair, clothes, etc. from coming into contact with the rotating brushes or discs.
If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips, as special tools and/or parts are required.
Preparing the appliance for use
C
2 |
2 |
|
1
C
2 |
2 |
|
1
1 C
2
1Connect the upper part of the handstick to the handle by means of the screws provided.
2Connect the upper part of the handstick to the lower part of the handstick by means of the screws provided.
3Place the handstick in the base of the appliance. Use the screws provided to secure the connections.
2
C
C
ENGLISH 5
4 Slide the top of the dustbag in the upper dustbag holder.
5 Connect the bottom of the dustbag to the appliance.
C 6 Remove the two metal clamps by turning one of the rubber wheels with your hand. Do not put the clamps back between the wheels.
C 7 Attach the brushes or the polishing discs.You will hear a click when you attach them properly.
C 8 To detach the brushes or polishing discs, simply pull them off the appliance.
Before polishing
1Clean the floor with a vacuum cleaner.
2Remove stains, etc.
Loading...