Pentax TH5320, TH5320R, YTH5320, YTH5320R Owner's Manual

Operating Manual

69-2094EFS-05

FocusPro® TH5320R

Wireless Thermostat Thermostat Sans Fil Termóstato inalámbrico

Operating Manual

Battery Holder

Press down and pull to remove batteries.

Batteries should be replaced once a year (see page 11).

M28430

CAUTION: EQUIPMENT DAMAGE HAZARD. To prevent possible compressor damage, do not operate cooling system when outdoor temperature is below 50°F (10°C).

Need Help?

For assistance with this product please visit http://yourhome.honeywell.com

or call Honeywell Customer Care toll-free at 1-800-468-1502

Read and save these instructions.

® U.S. Registered Trademark. Patents pending

Contents

Français : voir la page 15 • Español: vea la página 30

About your new thermostat

Initial setup ......................................... 2

Quick reference to controls ................. 3

Quick reference to display .................. 4

Operation

Fan settings (auto/on) ......................... 5

System settings (heat/cool) ................ 6

Auto-changeover (heat/cool)............... 7

Remote control ................................... 8

Display outdoor climate ...................... 9

Find lost remote control ...................... 9

Compressor protection ..................... 10

1 69-2094EFS—05

Appendices

Battery replacement ......................... 11

In case of difficulty ............................ 13

Limited warranty ............................... 14

Regulatory information ..................... 45

Operating Manual

About your new thermostat

Your new wireless thermostat is pre-set for immediate use. All you have to do is choose the settings you prefer:

1. Select fan setting (Auto/On) .................................................See page 5

2. Select system setting (Heat/Cool) .......................................See page 6

69-2094EFS—05 2

FocusPro® TH5320R Wireless Thermostat

Quick reference to controls

Digital display (see page 4) Battery holder (see page 11)

Temperature buttons

Press to adjust temperature

M28431

Function buttons

Press to select the function displayed just above each button. (Functions change depending on the task.)

3 69-2094EFS—05

Operating Manual

Quick reference to display screen

Current inside temperature Low battery warnings (see pages 11-12)

Indoor

Fan

Auto

Fan Setting

Auto/On (see page 5)

69-2094EFS—05 4

Replace Battery

Aux Heat On

System More

Heat

System setting

Heat/Cool/Auto/Off/Em Heat (see page 6)

Heat

Setting

Temperature setting

Auxillary heat

(Only for heat pumps with auxillary heat)

System status

Heat On/Cool On (If flashing, see page 10)

M28432

Press to view outdoor climate (if outdoor sensor is installed), or to find a misplaced remote control if installed (see page 9)

Select the fan setting

FocusPro® TH5320R Wireless Thermostat

Fan System More

Auto

Fan System More

Heat

M28433

M28434

Press FAN to select Auto or On. In “Auto” mode (the most commonly used

setting), the fan runs only when the heating or cooling system is on.

If set to “On,” the fan runs continuously.

Note: Options may vary depending on your heating/ cooling equipment.

5 69-2094EFS—05

Operating Manual

Select the system setting

Fan System More

Auto

Fan System More

Auto

Heat

M28435

Cool

M28436

Note: Options may vary depending on your heating/ cooling equipment.

69-2094EFS—05 6

Press SYSTEM to select:

• Heat: Thermostat controls only the

heating system.

• Cool: Thermostat controls only the

cooling system.

• Off: All systems are off.

• Auto: Thermostat automatically selects

heating or cooling depending on the indoor temperature.

• Em Heat (only for heat pumps with

auxiliary heat): Thermostat controls Emergency and Auxiliary Heat. Compressor is locked out.

Auto Changeover (heat/cool)

FocusPro® TH5320R Wireless Thermostat

Fan System More

Auto

Auto changeover is a feature used in climates where both air conditioning and heating are often used on the same day. When the system is set to Auto, the ther-

MCR28437

mostat automatically selects heating or cooling depending on the indoor temperature.

Press until screen displays “Auto”

Heat and cool settings must be at least 3 degrees apart. The thermostat will automatically adjust settings to maintain this 3 degree separation.

Note: The Auto system setting may not appear, depending on how your thermostat was installed.

7 69-2094EFS—05

Operating Manual

Remote Control

Temperature is measured at location of remote control

Remote

at Thermostat

Fan

Auto

Note: The thermostat may take up to 15 seconds to respond to commands entered at

the remote control. See Remote Control Operating Manual for more information.

69-2094EFS—05 8

has Control

Cancel

Reading at Remote

MCR28438

The optional remote control can act as a mobile thermostat, to maintain a comfortable temperature as you move from room to room.

When the system is responding to temperatures measured at the Remote, the thermostat will display “Remote has Control.”

Press CANCEL to restore temperature control to the thermostat (the system will only respond to temperatures measured at the thermostat).

Additional Features

Fan System More

Auto

Press to diplay more options.

Outdoor temperature

Outdoor

Heat

Outdoor humidity

Outdoor Humidity

MCR28439

FocusPro® TH5320R Wireless Thermostat

To display outdoor climate

If you have an outdoor air sensor, press

MORE to display the current outdoor tempera-

ture and humidity. Press DONE to exit.

To find a lost remote control

If you misplace a remote control, press

MORE, then FIND REMOTE. The remote will

beep for two minutes to help you locate it.

Press anywhere on the display screen to stop the beeping.

Done

Press to find a lost remote control.

9 69-2094EFS—05

Find Remote

MCR28440

Operating Manual

Built-in compressor protection

This feature helps prevent damage to the compressor in your air conditioning or heat pump system. Damage can occur if the compressor is re-started too soon after shutdown. This feature forces the compressor to wait a few minutes before re-starting.

During the wait time, the display will flash the message Cool On (or Heat On if you have a heat pump).

69-2094EFS—05 10

Battery replacement (thermostat)

FocusPro® TH5320R Wireless Thermostat

Press down and pull to remove.

Install fresh batteries when the REPLACE

BATTERY warning begins flashing. The warning

flashes about two months before the batteries are depleted.

Remove the battery holder and install 2 fresh AA alkaline batteries.

After batteries are installed, the thermostat will

M28441

automatically restore communication with the wireless network within a few minutes.

Insert fresh AA alkaline batteries, then reinstall battery holder.

11 69-2094EFS—05

MCR28442MCR28442

Note: If batteries are inserted within 2

minutes, the time and day will not have to be reset. All other settings are retained in memory.

Operating Manual

Battery replacement (outdoor air sensor)

Remove sensor from bracket

Replace outdoor air sensor batteries when the REPLACE BATTERY OUTDOOR warning begins flashing on the the thermostat. The warning flashes about two months before the batteries are depleted.

Remove the sensor from the bracket, remove the cover and install 2 fresh AA lithium batteries.

After batteries are installed, the sensor will automatically restore communication with

M28443

the wireless network within a few minutes.

Remove cover and install 2 fresh AA lithium batteries

69-2094EFS—05 12

MCR28444MCR28444

In case of difficulty

FocusPro® TH5320R Wireless Thermostat

Heating or cooling system does not respond

Screen displays “No Signal”

13 69-2094EFS—05

• Checkcircuitbreakerandresetifnecessary.

• Makesurepowerswitchatheating&coolingsystemison.

• Makesurefurnacedoorisclosedsecurely.

• Wait5minutesforthesystemtorespond.

Thermostat has lost radio contact with the wireless network (usually because of a power outage). To restore power:

• Checkcircuitbreakerandresetifnecessary.

• Makesurepowerswitchatheating&coolingsystemison.

• Makesurefurnacedoorisclosedsecurely.

After power is restored, the thermostat will automatically restore wireless communication within a few minutes.

Operating Manual

Up to 5-year limited warranty

Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and service, for a period of three (3) years from the date of purchase by the consumer. If at any time during the warranty period the product is determined to be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option).

If the product is defective, (i) return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it; or (ii) call Honeywell Customer Care at 1-800-468-1502.

Customer Care will make the determination whether the product should be returned to the following address: Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr. N., Golden Valley, MN 55422, or whether a replacement product can be sent to you.

This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that the

defect or malfunction was caused by damage which occurred while the product was in the possession of a consumer.

Honeywell’s sole responsibility shall be to repair or replace the product within the terms stated above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY

69-2094EFS—05 14

KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.

THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE THREE-YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

If you have any questions concerning this warranty, please write Honeywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502. When the product is registered on-line at www.warranty.Honeywell.com, the standard manufacture coverage stated above extends to a period of (5) years.

+ 36 hidden pages