Panasonic WV-CU151 User Manual
System Controller
WV-CU151
Before attempting to connect or operate this product, please read these instructions completely
The serial number of this product may be found on the
bottom of the unit.
You should note the serial number of this unit in the
space provided and retain this book as a permanent
record of your purchase to aid identification in the event
of theft.
Model No.
Serial No.
THIS APPARATUS MUST BE EARTHED.
To ensure safe operation the three-pin plug supplied must be inserted only into a standard three-pin power point which is effectively
earthed through the normal household wiring. Extension cords used
with the equipment must be three-core and be correctly wired to provide connection to earth. Wrongly wired extension cords are a major
cause of fatalities.
The fact that the equipment operates satisfactorily does not imply
that the power point is earthed and that the installation is completely
safe. For your safety, if in any doubt about the effective earthing of
the power point, consult a qualified electrician.
The lightning flash with arrowhead symbol, within an equilateral triangle, is
interned to alert the user to the presence
of uninsulated "dangerous voltage" within
the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating
and maintenance (servicing) instructions
in the literature accompanying the appliance.
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIS
TURE.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK), NO USER
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
For Australia
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
This appliance is supplied with a moulded three pin mains plug for your
safety and convenience.
A 13 amp fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement
fuse has a rating of 13 amp and that it is approved by ASTA or BSI to
BS1362.
Check for the ASTA mark
H or the BSI mark G on the body of the
fuse.
If the plug contains a removable fuse cover you must ensure that it is
refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement
cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic
Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE
REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE
CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.
If a new plug is to be fitted please observe the wiring code as shown
below.
If in any doubt please consult a qualified electrician.
WARNING: This apparatus must be earthed.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code.
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wire in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows.
The wire which is coloured green-and-yellow must be connected to
the terminal in the plug which is marked with the letter E or by the earth
symbol
I or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal in
the plug which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
in the plug which is marked with the letter L or coloured red.
How to replace the fuse
Open the fuse compartment with
a screwdriver and replace the fuse
and fuse cover.
For U.K.
ENGLISH VERSION
Wij verklaren als enige aansprakelijke, dat het product waarop deze
verklaring betrekking heeft, voldoet aan de volgende normen of
andere normatiefve dokumenten, overeenkomstig de bepalingen
van Richtlijnen 73/23/EEC en 89/336/EEC.
Vi erklærer os eneansvarlige for, at dette produkt, som denne
deklaration omhandler, er i overensstemmelse med den følgende
standarder eller andre normative dokumenter i følge bestemmelserne i direktivene 73/23/EEC og 89/336/EEC.
Vi deklarerar härmed värt fulla ansvar för att den produkt till vilken
denna deklaration hänvisar är i överensstämmelse med standarddokument, eller andra normativa dokument som framstölls i Direktiv
73/23/EEC och 89/336/EEC.
Ilmoitamme yksinomaisella vastuullamme, että tuote, jota tämä
ilmoitus koskee, noudattaa seuraavia standardeja tai muita ohjeellisia asiakirjoja, jotka noudattavat direktiivien 73/23/EEC ia
89/336/EEC. säädöksiä.
Vi erklærer oss alene ansvarlige for at produktet som denne
erklæringen gjelder for, er i overensstemmelse med følgende
normer eller andre normgivende dokumenter som fælger bestemmelsene i direktiven 73/23/EEC og 89/336/EEC.
We declare under our sole responsibility that the product to which
this declaration relates is in conformity with the standards or other
normative documents following the provisions of Directives
EEC/73/23 and EEC/89/336.
Caution:
Before attempting to connect or operate this product,
please read the label on the bottom.
Noi dichiariamo sotto nostra esclusiva responsabilità che il prodotto
a cui si riferisce la presente dichiarazione risulta conforme ai
seguenti standard o altri documenti normativi conformi alle disposizioni delle direttive CEE/73/23 e CEE/89/336.
-1-
CONTENTS
PREFACE ........................................................................................................................................................................................... 2
FEATURES ......................................................................................................................................................................................... 2
PRECAUTIONS .................................................................................................................................................................................. 2
MAJOR OPERATING CONTROL AND THEIR FUNCTIONS ............................................................................................................. 3
CONNECTIONS ................................................................................................................................................................................. 5
SYSTEM CONNECTION .................................................................................................................................................................... 6
OPERATING PROCEDURE ............................................................................................................................................................... 8
INSTALLATION .................................................................................................................................................................................. 16
SPECIFICATIONS .............................................................................................................................................................................. 18
OPTIONAL ACCESSORIES ............................................................................................................................................................... 18
The model numbers listed in this Operating Instructions have no suffixed attached to it.
ENGLISH
-2-
PREFACE
The Panasonic System Controller WV-CU151 is designed
for use with the Combination Camera WV-CS600 / WVCS400 or Receiver WV-RC100 / WV-RC150 / WV-RC170.
Multiplexed control signal on the video signal over a single
coaxial cable saves the expense of wiring cost.
The built-in alarm output connector allows to supply the
alarm signal to the external equipment.
FEATURES
1. Setting and selection of the Program menu are available.
2. Controllable functions are manual panning and tilting
of the Pan-tilt Head, Focus/Zoom/Iris Control for a
specified lens, Power on/off of the camera Wiper and
Defroster on/off Auxiliary relay on/off selection.
PRECAUTIONS
• Do not attempt to disassemble the instrument. In order
to prevent electric shock, do not remove screws or
covers. There are no user-serviceable parts inside.
Do refer all servicing to qualified service personnel.
• Do not abuse the instrument. Avoid striking, shaking,
etc. It could be damaged by improper handing or storage. Do handle the instrument with care.
• Do not use strong or abrasive detergents when cleaning the instrument body. Do use a dry cloth to clean
the instrument when dirty. In case the dirt is hard to
remove, use mild detergent and wipe gently.
• Do not expose the instrument to water or moisture, and
do not operate in wet area. Do take immediate action if
ever the instrument does become wet. Turn the power
off and refer servicing to qualified service personnel.
Moisture can damage the instrument and also create
the danger of electric shock.
• Do not use the instrument in an extreme environment
where high temperature or high humidity exist. Use the
instrument under conditions where temperature are
within under conditions where temperature are within
−10°C - +50°C, and humidity is below 90%.
• Make sure before installing pan-tilt head or lens if they
are usable.
• Set the Mode Selection Switch (LOCAL/REMOTE) on
the specified camera to the REMOTE position when
connecting it with this unit.
• Audio transmission is not available.
• Multiple operation of the unit is available.
• Every necessary procedure with regard to installing
this product should be made by qualified service personnel or system installers.
• The input power source must be 230 - 240V AC for
WV-CU151/A and WV-CU151/B, 230V AC for WVCU151/G at 50Hz.
-3-
MAJOR OPERATING CONTROL AND THEIR FUNCTIONS
■ Front Panel
System Controller WV-CU151
POWER
3
6
9
2
5
8
0
1
4
7
UPUP
DOWN
L
R
SET
AF
IRIS
ZOOM
HOUSING
PAN
l
ON
BUSYPOWER
HOME POSI
NEAR FAR
FOCUS
OPEN
WIDE
CLOSE
1
PROS
CAM
MENU
ALARM
RANDOM
2
WIPER
AUTO
AUX
;
OFF
DEF
SHIFTRESET
TELE
1. Power ON/OFF Switch (POWER: ON/OFF)
This switch is used to turn on and off the power of the
unit.
Note: When the power switch is turned on, the power
for the camera which is supplied by the Receiver
becomes on. However, when the power switch is
turned off while the camera and the Pan-tilt head
are working, the Receiver keeps supplying the
power to the camera and the pan-tilt head.
2. Power Indicator
Indicates the Power On.
3. Alarm Reset Switch (ALARM RESET)
Used to reset the alarm signal manually.
The LED on this switch will light off from blinking after
completing the reset.
When this unit is return to the initial mode due to the
automatic reset function or recover signal supply, the
LED on this switch will light on from blinking.
4. Busy Indicator (BUSY)
Indicates the busy condition.
To operate this unit is not possible during lighting.
5. Shift Switch (SHIFT)
Used to select the functions of the Program Selection
Switch, Panning Selection Switch, Auxiliary Selection
Switch, Zoom/Iris Switches and Housing Switch.
Lighting: Selects the PROG, CLOSE, OPEN, WIPER,
AUX2 or RANDOM.
Lighting Off: Selects the CAM MENU, TELE, WIDE,
DEF, AUX1 or AUTO.
6. Camera / Program Menu Selection Switch
(CAM MENU/PROG)
Used to select the display menu.
CAM MENU: Displays the set up menu of the camera.
PROG: Displays the program menu of this unit.
CAM MENU and PROG selection should be made in
accordance with the Shift Switch setting.
When the selected function is activated, its indicator
will light.
7. Zoom / Iris Control Switch
(ZOOM: TELE/WIDE, IRIS: CLOSE/OPEN)
ZOOM : Controls the lens zoom. (Tele - Wide)
IRIS: Controls the lens iris. (Close - Open)
When the shift switch lights, the open or close position
can be selected.
Note: This control works to the specified camera, such
as the WV-CS600 or WV-CS400.
8. Focus Control Switch (FOCUS: NEAR /FAR)
Used to control the lens focus.
9. Panning Selection Switch (PAN: AUTO, RANDOM)
Selects the automatic or random panning.
The movement of the random panning has been preprogrammed by a micro-processor in the specified
receiver. The random panning functions when the
specified pan/tilt head is used.
The automatic random functions when WV-CS600, WVCS400 or the equivalent is used.
• When the shift switch lights, the random panning can
be selected.
Loading...