Panasonic WJ-NV200 Installation Guide

New functions (Software V2.10)

Due to software upgrade, the following new functions have become available.

Details on the new functions

The "Dual mode" that can record the same images and audio on two

HDDs is added to the HDD operational mode.

Refer to "■ About the HDD operational mode" (page 3) for further

information.

Important:

 This function supports only the models in which 2 HDDs can be

installed.

When using this function, disk size of two hard disk drives to be

used shall be the same.

 After replacing one of the HDDs, it is impossible to copy data on

the existing HDD to the replaced HDD using this software. (No

recovery function is featured.)

 When the existing HDD (not replaced one) doesn’t exist, the

recorded data of a certain period* after replacing the HDD cannot

be played.

* In case of overwriting in one month, up to two days.

Reference pages

Installation Guide

page 81

The alarm history relating to the i-VMD of the camera is added.

Intruder detection: Camera alarm (Intruder detection)

Loitering detection: Camera alarm (Loitering detection)

Direction detection: Camera alarm (Direction detection)

Scene change detection: Camera alarm (Scene change detection)

Note:

 This function is available when “On” is selected for “Additional

alarm area data” on the camera. For further information about

this setting, refer to the operating instructions of the camera in

use.

Operating Instructions

page 38, page 62

1

Details on the new functions

Reference pages

The following camera setting items can be configured on the recorder.

 Transmission priority (Frame rate/Advanced VBR)

Note:

 For further information about these functions, refer to the

operating instructions of the camera in use.

The release key number of the camera's extension software can be

registered in the camera from this product now.

By using the viewer software, the function that compensates and

converts fish-eye images captured by Panasonic's 360-degree network

camera (hereinafter referred to as 360-degree camera) to "1-screen PTZ"

or "4-screen PTZ" is now available.(Compensation function)

Important:

 The compensation function is available only when the library file

for compensation is downloaded from the URL below and

installed on the PC in which the viewer software is installed.

http://security.panasonic.com/pss/security/support/info.html

Installation Guide

page 48

Installation Guide

page 58, page 82

Operating Instructions

page 88

 When images that can be compensated are detected, the

/ / buttons will be displayed.

Click one of them to change the compensation method.

: Get back to fish-eye image.

: Compensate and convert to "1-screen PTZ".

: Compensate and convert to "4-screen PTZ".

 When displaying images that are compensated and converted to

"1-screen PTZ" or "4-screen PTZ", it is possible to make a desired

point to position as the center point of the image by clicking on the

image.

2