Panasonic WINDB-P1 installation

Panasonic Corporation of North America

1690 Roberts Blvd., NW, Suite 110 Kennesaw, GA 30144

Tel: 770.977.8510

INSTALLATION INSTRUCTIONS

Panasonic Universal Wind Shield (Baffle) Part Number: WINDB-P1

CONTENTS INCLUDED: 2 side panels, 1 top panel, 2 back panels, 8 sheet metal screws, 8 washers, 8 spacers, 24

screws, 24 locknuts and 24 shoulder spacers.

GENERAL: This wind shield is sized so it will fit onto the rear (Coil Side) of a Panasonic outdoor mini split unit with

model numbers U-26PE1U6, U36PE1U6

INSTALLATION PROCEDURES:

Remove all the protective film on the clear parts. Pre assemble all parts (Fig 1 and Fig 2).

BEFORE DRILLING OR SCREWING INTO THE UNIT, MAKE SURE THERE WILL BE NO CONTACT WITH REFRIGERANT TUBING OR ELECTRICAL WIRES. CHECK FOR CLEARANCE.

Fasten the assembled wind baffle to the unit using the provided drill tip screws, nylon spacers and washers (Fig 3). Note that the top of the baffle will be about 4 in + - above the top of the unit. This will give the unit extra protection from wind and hail.

Unit

Nylon Spacer

Clear Part

FIG. 3

Unit

Stainless Steel Washer

Drill Tip Screw

FIG. 1

Outer or Top Part

Lock Nut

FIG. 2

Caution: Do not over tighten lock Nut. Tighten nut until slightly

snug, then back off until it will

lightly twist or spin.

Screw

Shoulder Spacer

Inner or Under Part

Caution: Use only mild soap or detergent and water to clean baffle. Do not use any chemicals