Panasonic WINDB-LB2S installation

Panasonic Corporation of North America

1690 Roberts Blvd., NW, Suite 110
Kennesaw, GA 30144

INSTALLATION INSTRUCTIONS

Panasonic VRF Snow Shield Part Number: WINDB-LB2S

Tel: [phone]

CONTENTS INCLUDED: 6 side panels, 1 Back A panel, 1 back B panel, 2 cap A panels, 36 sheet metal screws, 36

washers, 36 spacers, 50 screws, 50 locknuts, 50 shoulder spacers and 1 alignment tool.

GENERAL: This snow shield is sized so it will fit the sides and back of Panasonic VRF Condensing units: U-**ME2U9,

U-**MF2U9, U-**ME2U94, U-**MF2U94.

INSTALLATION PROCEDURES:

Remove all the protective film on the parts. Install the CAP A to 2 side panels (Fig. 3) with the fasteners as show in Fig.

1. To help align parts for use with the fasteners, insert the alignment tool in a hole adjacent to the hole being
fastened. Install the BACK A and BACK B to 2 side panels (Fig 4) with the fasteners as show in Fig. 1. To fasten the
assembled snow shield to the unit with fasteners as shown in Fig. 2, start with the holes on the top of the 2 side panels
first. This will hold the snow shield in place while installing the remaining fasteners. Slowly install the self-drilling

screws using caution not to strip out the metal of the unit. Only use provided fasteners to attach this product to the

unit – failing to so, may void your warranty.

Fig. 3

CAUTION!

BEFORE DRILLING OR SCREWING INTO THE UNIT, MAKE
SURE THERE WILL BE NO CONTACT WITH REFRIGERANT

TUBING OR ELECTRICAL WIRES. CHECK FOR

CLEARANCE.

Outer or Top Part

Screw

Lock Nut

Inner or Under Part

Fig. 1

Caution: Do not over tighten lock Nut. Tighten nut
until slightly snug, then back off until it will lightly
twist or spin.

Unit

Nylon Spacer

Stainless Steel Washer

Shoulder Spacer

Fig. 4

Drill Tip Screw

Clear Part

Caution: Use only mild soap or detergent and water to clean baffle. Do not use any chemicals

Fig. 2