Panasonic SBWAK-960-GCP Service manual
T
Specification
ORDER NO. MD0707026CE
Speaker System
SB-WAK960GCP
Colour
(K)... Black Type
ype 1 way, 1 speaker system (Bass reflex)
Speaker unit(s) Impedance 7 Ω
1. Woofer 25 cm cone type
Input power (IEC) 250 W (Max)
Output sound pressure 82 dB/W (1.0 m)
Frequencyrange 48 Hz to 250 Hz (-16 dB)
50 Hz to 200 Hz (-10 dB)
Dimensions (W x H x D) 320 mm x 411 mm x 330 mm
Mass 6.8 kg
Notes :
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.
© 2007 Matsushita Electric Industrial Co. Ltd.. All
rights reserved. Unauthorized copying and
distribution is a violation of law.
SB-WAK960GC P
1 System Combination
1.1. System Breakdown
Note :
The tables below show the breakdown for speaker combinations used in main unit systems.
System SF-VK960GCPK
Music center SA-VK960GCPK
Front speakers
Speaker system SB-AK960GCPK
Surround speakers SB-PS960GCPK
Subwoofer SB-WAK960GCPK
Active subwoofer SB-WAK860GCPK
SB-AK960GCPK consists of SB-PS960GCPK (x2), SB-WAK960GCPK (x1) and
SB-WAK860GCPK (x1)
1.2. Packaging Information (SB-WAK960GCPK)
Note :
For more information on the complete packaging condition for speakers in SB-AK960GCPK, please refer to section 4.3 in
service manual of SB-PS960GCPK (MD0707025CE).
SB-PF960GCPK
2
2 Assembling and Disassembling
“ATTENTION SERVICER”
Some chassis components may have sharp edges. Be careful when disassembling and servicing.
1. This section describes procedures for checking the operation and replacing the main components.
2. For reassembly after operation checks or replacement, reverse the respective procedures.
Special reassembly procedures are described only when required.
3. Select items from the following index when checks or replacement are required.
4. Refer to the Parts No. on the page of “Parts Locatio n and Replacement Parts List” (Section 5), if necessary.
Below is the list of disassembly sections
• Disassembly of Front panel assembly
• Disassembly of Subwoofer (SP1)
SB-WAK960GC P
3
SB-WAK960GC P
2.1. Disassembly of Front panel
assembly
Step 4: Upset the speaker unit as shown above.
Step 5: Insert a flathead screwdriver above the steel rule as
arrow shown.
Step 1: Remove 4 screws.
Step 2: Upset the speaker unit as shown above.
Step 3: Insert a steel rule into the grooves of front panel
assembly. Push the steel rule as arrow shown.
Caution:
Do not exert strong force as it may damage the front panel
assembly.
Step 6: Apply light force along the bosses to push up the front
panel assembly.
Step 7: Remove the front panel assembly as arrow shown.
4
Loading...