Panasonic lns-m01, lns01 Operation Manual

PARTS LIST

Following parts are contained in the packing.

· LENS

· LENS MOUNTING SCREWS

· DRIVER

· LIGHT-BLOCK SHEET

NOTES ON LENS INSTALLATION

LCD PROJECTOR LENS

MODEL NO. LNS-M01

LNS-S01

Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens. If you have any questions, contact to the dealers.

Following checks and confirmations should be taken for safety.

Check the following things by the time of the cabinet assembly after the lens installation.

1. Confirm the lens is securely fixed by 4 screws.

2.Wiring must not be tangled in the gear of the lens motor or the other mechanical part.

3.There is no missing part, or no loosing mounting part.

1AA6P1P1980-- (ICPP)

1 piece 6 screws (2 for spare) 1 piece 1 sheet

LENS REPLACEMENT AND INSTALLATION PROCEDURE

Remove screws A (2 screws). Pull down the lower lens cover while pushing

the part D, then remove it. Remove screws B (2 screws). Remove screws C (2 screws) and remove

upper lens cover.

Perform the steps to for lens replacement and installation.

Fig-1

Fig-2

● IN CASE OF MODEL WITHOUT LENS

Remove 2 screws and pull down the plate.

UPPER LENS COVER

LOWER LENS COVER

COVER PLATE

REMOVE THE LENS COVER. (See figure-1)

(At the step , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used.)

Use the light-block sheet included with lens. Set the light-block sheet, so that the large rounder side is set over the lens.

REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2)

LENS MOT OR LEAD

CONNECTOR “ K16B”

(D)

LENS MOT OR

Fig-3

❋Figure shown inside of the cabinet.

REMOVE THE LENS. (See figure-3.)

1. Remove the connector “K16B” of the circuit board.

2. Loosen the A, B wire holder and remove the lens motor lead.

3. Remove screws D (4 screws) which fastens the lens and remove the lens.

● IN CASE OF MODEL WITH LENS

Set the light-block sheet, so that the large rounder side is set over the lens.

SCREWS

WIRE HOLDER

+ 4 hidden pages