Panasonic DVD-RV41, DVD-RV31 User Manual
Specifications and Main Features
- Models: DVD-RV41, General DVD RV31
- Power supply: For UK and Europe, it ranges from AC 220 to 240 V, 50 hertz and for Australia/NZ it ranges from 110 to 240 V and 50 to 60 hertz.
- Power Consumption: 14W; however in idle mode the power consumption is 19W.
- Dimensions: The model’s dimensions are 430 mm in width, 82 mm in height and around 247 mm in depth, these dimensions do not include the extrusions of the model.
- Mass: The mass of this model is 2.6 kg.
- Operating Temperature Range: This Model can function within the temperature range of 5 to 35 degrees Celsius.
- Operating Humidity Range: The ideal humidity range for the model to operate properly is 5 to 90 percent relative humidity, which means no condensation.
- Discs that can be played include DVD Video, CD Audio, Video CD, CD-R and CD-RW.
- Signal system: NTSC, PAL 625/50 and PAL 525/60
- Video Output: The model has a video output of 1Vp-p 75 ohm.
- S video output: 1 Vp-p which has an impedance of 75 ohm.
- Outputs for Other Video Signals;
Y Output Level: For NTSC systems 0.286 Vp-p and 75 ohm impedance, for PAL 0.300 Vp-p and 75 ohm.
Audio Output Level: The model has a 2 Vrms audio output with a frequency of 1 kHz and dB of 0.
- Frequency Response:
- For DVD (Linear Audio); The frequency range is 4 Hz to 22 kHz with a sampling of 48 khz, and ranges from 4hz to 44k Hz with a sampling of 96 Khz.
- For CD audio: The audio range is from 4Hz to 20 Khz.
- S/N ratio: The ratio for CD audio is at 115dB
- Dynamic range; For DVDs the dynamic range is from 98dB to 102dB while for CD audio it is 98dB.
- Total harmonic distortion: The total harmonic distortion for CD audio is 0.0025%
- Optical digital output: Comes with an optical terminal.
- Laser wavelength: 658nm and 790 nm and class 2a/1 lasers.
Frequently Asked Questions
- Q: What type of discs does this player take?
A: This player supports DVD-Video, CD-Audio (CD-DA), VCD and CD-R/CD-RW.
- Q: Am I able to use this player with PAL types in addition to NTSC?
A: This device accepts signals from both PAL and NTSC formats.
- Q: Is there a way to change audio through the player if I am already playing a DVD?
A: Press the [AUDIO] button on the control by the player.
- Q: Is it possible to use this player with a surround system?
A: This device can be used with a 5.1-channel amplifier and surround systems.
- Q: What can be done when the unit is not powered?
A: Get the mains lead connected appropriately and the socket being used checked.
- Q: What steps must I take to make the player start configuring in factory settings?
A: With the player off, press and hold [I] and [#4] on the unit together and then press and hold [4] which will set the settings back to factory.
- Q: Why is the image not being displayed normally?
A: Make sure the correct input for the video is connected on the television and that the correct unit is being used.
User Manual
Loading...