Panasonic Cw-xc145hu Owner's Manual

Models: CW-XC145HU
CW-XC185HU CW-XC245HU
Please read these operating instructions thoroughly before using your air conditioner and keep for future reference.
For assistance, please call: 1-800-211-PANA(7262) or Register your product at : http://www.panasonic.com/register
CW382820391S
R
INSTALLATION AND OPERATING INSTRUCTIONS
2
Safety Precautions
About the Controls on the Air Conditioner
Features and Installation
Before you call for service...
FOR YOUR RECORDS
Staple your receipt to this page in case you need it later. Write down the model and serial numbers here:
Model # Serial #
You can find them on a label on the side of each unit.
Dealer's Name Date Purchased
Inside you will find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive care on your part can save you a great deal of time and money over the life of your air conditioner.
You'll find many answers to common problems in the chart of troubleshooting tips. If you review our chart of Troubleshooting Tips first, you may not need to call for service at all.
READ THIS MANUAL
CAUTION
• Contact an authorized Service technician for repair or maintenance of this unit.
• The air conditioner is not intended for use by young children or infirm persons without supervision.
• Young children should be supervised to ensure that they do not play with the air conditioner.
Safety Precautions
Safety Precautions.............3
About the Controls on the Air Conditioner
Controls..............................5
Remote Controller..............6
Ventilation ..........................7
Air Direction........................7
How to Secure Drain Pipe
....7
Care and Maintenance
Air Filter Cleaning...............8
How to Insert Batteries.......8
Features
Features.............................9
Installation
How to Install the Unit......10
Window Requirements.....10
Installation Kit Contents ...11 Suggested Tool
Requirements...................12
Cabinet Installation...........13
Electrical Data..................15
Electrical Safety ...............16
Before you call for service...
Normal Operation.............17
Abnormal Operation.........17
WARNING
3

Safety Precautions

Safety Precautions

To prevent injury to the user or other people and property damage, the following instructions must be followed.
Incorrect operation due to ignoring of instruction will cause harm or damage. The seriousness is classified by the following indications.
Meanings of symbols used in this manual are as shown below.
Plug in the power plug properly.
• Otherwise, it will cause electric shock or fire due to heat generation.
Do not operate or stop the unit by inserting or pulling out the power plug.
• It will cause electric shock or fire due to heat generation.
Do not damage or use an unspecified power cord.
• It will cause electric shock or fire.
If the power cord is damaged, it must be replaced by the manufacturer or an authorized service center or a similarly qualified person in order to avoid a hazard.
Do not modify power cord length or share the outlet with other appliances.
• It will cause electric shock or fire due to heat generation.
Do not operate with wet hands or in a damp environment.
• It will cause electric shock.
Do not direct air flow at room occupants.
• This could lead to health problems.
WARNING : This symbol indicates the possibility of death or serious injury. CAUTION
:
This symbol indicates the possibility of injury or damage to property only.
Be sure not to do this.
Be sure to follow the instructions.
4
Safety Precautions
When the air filter is to be
removed, do not touch the
metal parts of the unit.
• It may cause an injury.
Do not clean the air
conditioner with water.
• Water may enter the unit and degrade the insulation. It may cause an electric shock.
Ventilate well when used
together with a stove, etc.
• An oxygen shortage may occur.
When the unit is to be
cleaned, switch off, and turn
off the breaker.
• Since the fan rotates at high speed during operation, it may cause an injury.
Do not put a pet or house
plant where it will be exposed
to direct air flow.
• This could injure the pets or plants.
Do not use for special
purposes.
• Do not use this air conditioner to preserve precision devices, food, pets, plants, and art objects. It may cause deterioration of quality, etc.
Do not operate switches
with wet hands
.
• It may cause an electric shock.
Do not apply an insecticide
or flammable spray.
• It may cause a fire or deformation of the cabinet.
Do not put a heater, etc.
where it is exposed to direct
air flow.
It may cause imperfect combustion.
5

About the Controls on the Air Conditioner

2
1
7
4 6
3
5
About the Controls on the Air Conditioner

Controls

OPERATION
To turn the air conditioner ON, push the button. To turn
the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
When you first turn it on, the air conditioner is on the
High cool mode and the temperature is set at 72°F (22°C)
MODE
Every time you push this button, it will toggle between COOL, ECONOMY, FAN, DRY.
TEMPERATURE SETTING
This button can automatically control the temperature of the room. The temperature can be set within a range of 60°F to 86°F by 2°F. (16°C to 30°C by 1°C) Select a lower number for a lower temperature in the room.
FAN SPEED
Every time you push this button, it is set as follows. {High(F3) Low(F1) Med(F2) High(F3)...}.
ON/OFF TIMER
You can set the time when the unit will turn on or turn off automatically by pressing the timer button. If the unit is operating, this button controls the time it will be turned off. If the unit is in off state, this button controls the time it will start. Every time you push this button, the remaining time will be set as follows.
- STOPPING OPERATION
Every time you push this button, when the air conditioner is operating, timer is set as follows. (1Hour 2Hours 3Hours 4Hours 5Hours 6Hours 7Hours 8Hours 9Hours 10Hours 11Hours 12Hours 0Hour 1Hour 2Hours ...)
The Setting Temperature will be raised by 2°F(1°C) 30min. later and by 2°F(1°C) after another 30 min.
- STARTING OPERATION
Every time you push this button, when the air conditioner is not operating, timer is set as follows. (1Hour 2Hours 3Hours 4Hours 5Hours 6Hours 7Hours 8Hours 9Hours 10Hours 11Hours 12Hours 0Hour 1Hour 2Hours ...)
AIR SWING
This button can automatically control the air flow direction.
REMOTE CONTROL SIGNAL RECEIVER DRY
When this unit is in dry mode, the fan rotates in low speed. The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit checks the room air temperature to set itself.
6
About the Controls on the Air Conditioner
OPERATION
TEMP
TIMER
AIR
SWING
MODE
ECONOMY
FAN SPEED
1
5
2 4 7
3
6

Remote controller

OPERATION
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
When you first turn it on, the air conditioner is on
the High cool mode and the temperature is set at 72°F (22˚C).
MODE
Every time you push this button,it will toggle between COOL, ECONOMY, FAN and DRY.
TEMPERATURE SETTING
This button can automatically control the temperature of the room. The temperature can be set within a range of 60°F to 86°F by 2°F.(16˚C to 30˚C by 1˚C) Select a lower number for a lower temperature in the room.
FAN SPEED
Every time you push this button it is set as follows. {High(F3) Low(F1) Med(F2) High(F3)...}.
ON/OFF TIMER
- STOPPING OPERATION
Every time you push this button, when the air conditioner is operating, timer is set as follows. (1Hour 2Hours 3Hours 4Hours 5Hours 6Hours 7Hours 8Hours 9Hours 10Hours 11Hours 12Hours O)
The Setting Temperature will be raised by 2°F (1°C) 30 min. later and by 2°F (1°C) after another 30 min.
- STARTING OPERATION
Every time you push this button, when the air conditioner is not operating, timer is set as follows. (1Hour 2Hours 3Hours 4Hours 5Hours 6Hours 7Hours 8Hours 9Hours 10Hours 11Hours 12Hours O)
AIR SWING
This button can automatically control the air flow direction.
ECONOMY
If the switch is set to "On", the fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is needed.
DRY
When this unit is in dry mode, the fan rotates in low speed. The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit checks the room air temperature to set itself.
Precaution:
The Remote Controller will not function properly if strong light strikes the sensor window of the air conditioner or if there are obstacles between the Remote Controller and the air conditioner.
Loading...
+ 11 hidden pages