Panasonic CT-20G6DE Owner’s Manual

Panasonlc o

just slightly ahead of our time®

Your new TV Monitor/Receiver features a solid
state chassis that is designed to give you many

years el enjoyment. It was thoroughly tested and
tuned at the factory for best performance

Customer Record

The model and serial number of this product may
be found on the back of the unit You should note

the model and serial number in lhe space provided
and retain as a permanent record of your
purchase. This will aid in identification in the event

of theft or loss. Product registration is available for

U.S. customers at:

www.prodreg.com/panasonic

Model

Number

Serial
Number

Care and Cleaning

Screen (Turn TV Off)

Use a mild soap solution or window
cleaner with a soft clean cloth. DO NOT

USE ABRASIVE CLEANERS.
Avoid excessive moisture and wipe dry.

Note: Do not spray any type of cleaning fluid

directly on the screen.

Cabinet and Remote Control

Use a soft cloth dampened with water or
a mild detergent solution. Be not use
benzene, thinner, or other petroleum

based cleaners.
Wipe dry with a soft clean cloth. Avoid

excessive moisture.

Specifications

Power Source
CT-13R32 (0.9A)

CT-13R42 (0.9A)
CT-20D11 (1.4A)

CTo2006S (1.4A) 120V AC 6OHz

CT-2016S (1.4A)
CT-20G6 (1.4A)
CT-20R6 (1.3A)
CT-25G6 (1.8A)
CT-25G6U (1 .eA)

Channel Capability - 181 VHF-12 UHF-56

Video Input Jacks 1Vp p75 Ohm Phone

(some models) Jack Type

Audio input Jacks 500mV RMS 47K

(some models) Ohm

To Audio AMP Jack 0 2.0V RMS 47K

(some models) Ohm

Specifications are subiect to change without notice
or obligation.

Cable-113

Television Location

Follow these recommendations before deciding the
location of your television.

Avoid excessive sunlighl or bright lights,

including reflections.

CI Keep away from excessive heat or moisture

Inadequate ventilation may cause internal
component failure.

[] Fluorescenl lighting may reduce Remote

Control transmitting range.

_1 Avoid magnetic equipment, including motors,

fans, or external speakers.

CAUTION: Use this television

receiver only with the cart, stand, _._'_
tripod, bracket, or table specified by
the manufacturer, or sold with the
apparatus. When a cart is used, use
caution when moving the cart/apparatus
combination to avoid injury from tip-over. In order
to avoid injury to children, never place your
television receiver on a piece of furniture that is
capable of being tilted by a child leaning on it,

pulling on it, standing on it, or climbing on it.

AC Power Supply Cord

CAUTION: TO PREVENT

ELECTRIC SHOCK, MATCH _i i_

WIDE 8LADE OF PLUG TO

WIDE SLOT OF AC OUTLET Polarizedplug
ANO FULLY INSERT, DO NOT USE A PLUG

WITH A RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADE CAN BE FULLY INSERTED

TO PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING

WALKED ON, ROLLED OVER, CRIMPED, BENT
OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE
POINT WHERE THEY EXIT FROM THE
APPARATUS.

Batteries

Replace batteries in pairs.
DO not mix battery types (zinc carbon

with alkaline).
Do not recharge, short-circuit,

disassemble, heat, or burn used
batteries.

Optional Cable Connections

Shielded audio and video cables should be used
between components. For best results:

Use 75 ohm coaxial shielded cables
Use appropriate input and output

connectors that match your component
connectors.

Avoid long cables to minimize
interference

The lightning llash with The exclamation point

arrow head within a with1[3a triangle is intended

triangle is intended to _to tell the user that
tell the user that parts important operating and

'/_ inside the product are a L_ see'icing instructions are in

risk of electric Shock to the papers with the
persons appkiance

WARNING: To prevent fire or shock hazard, do
not expose this appliance to rain or moisture

Read these instructions completely before
operating TV.

Contents are subject to change without notice
or obligation.

°2-

Cable / Antenna

For proper reception, either a cable or antenna

connection are required.

Cable Connection

Connect the cable supplied by your local
cable company.

A cable converter box may be required for
proper reception. Check with your local

Cable company for compatibility
requirements.

Incoming Cable from Cable Company

21,

75Ohms VHF/UHF

onback of TV

Antenna Connection

For proper reception of VHF/UHF

channels, an external antenna is required.
For best reception an outdoor antenna is

recommended.

Antenna Mode must be set to TV.

VHF/UHF Antenna

A VHF/UHF antenna and transformer are
supplied in some models. Attach to the TV.

adjust the antenna until the picture is clear.
(See Antenna Connection).

Incoming Cable from Home Antenna

Note: Cable Mode is preset at the factory.

Antenna users must change to Antenna

Mode in the Set Up Menu.

Procedure

1 Connect equipment as shown to front or

rear Audio/Video input jacks

Note: Front and rear Audio/V_deo

connections cannot be
operated at the same ttme.

2. Select the Video mode by pressing TV/
VIDEO button.

3. Operate optional equipment as instructed
in equipment manual.

Note: VCRs, video disc players, video game

equipment, and DSS equipment can also
be connected to the antenna input
connection. (See your equipment

manual).

To Audio Amplifier (some models)

Connect to an external audio amplifier input for
listening to sound from a stereo system.

Note: TO AUDIO AMP terminals cannot be used

directly for external speakers.

Audio Adjustments

1. Select TV SPEAKERS ON from AUDIO
menu.

2. Set amplifier volume to minimum.

3. Adjust TV volume to desired level.

4. Adjust amplifier volume to match the TV.

5. Select OFF& VAO from AUDIO menu.

6. Volume and mute are now selected using
the TV controls.

Note: In OFF&FAO the volume is controlled by

the external amplifier.

O

nl

Terminalson back ofTV/some models)

9 • A_. i

/

INPUT

AUDIO- VIDEO_,.

_" i TO AUDIO

VIDEO L -AUDIO- R

STEREOMODELS

(oo o)

VIDEO L -AUDIO- R

o000)

Jack used for

1/8" earphone ug

(some mo_s)

VCR or Video Disc

Terminalson back ofVCR

Terminals on front of TV (some models)

MONO MODELS/_

Jack used for

1/8" earphone lug

(some mede's)

-3-

rn

VIDEO AUDIO

ACTION Button

Press the ACTION button to display the Main Menu
and submenus. Press the ACTION button repeatedly
to exit.

Note: Models with no audto features will not

display AUDIO icon in the Main Menu

Main Menu

I EXIT

OH / VOL Buttons

Press the CH (channel) or VOL (volume) buttons to

select an icon. Press ACTION button to display the

icon features and sub menus. Use the CH buttons to
highlight the desired features. Use VOL buttons to

select and adjust features.

Timer

Sleep Timer

In TIMER menu, program to turn TV OFF in 30, 60, or
90 minutes Select NO to turn ott timer.

lll_l:;I;i

Program Timer

In Timer menu, program TV to automatically turn on
and off at selected time on a selected channel or one

of nine pre set FM stations, daily or one day.

Note: TIME must be entered in the TIMER menu to

operate PROGRAM TIMER.

Remote Navigation Buttons

CH

VOL VOL

CH

Remote Control

The Remote Control Quick Reference Guide is

located in the package provided with the TV.

Languages

In SETUP menu, select ENGLISH, ESPAI_OL, OR
FRAN_AIS.

Helpful Hints: PROGRAM TIMER
Activation

The PROGRAM TIMER is active when the TV is
OFF o[ ON. The TV will switch to the selected

channel at the selected time set by the PROGRAM
TIMER.

Helpful Hints: Turn Off After 90
Minutes

The TV automatically turns OFF after 90 minutes
when turned on by the PROGRAM TIMER. If the
OFF time is programmed or if a key is pressed, the

automatic OFF after 90 minutes will be cancelled.

CH CAP (Channel Caption)

Program channel captions (station labets) for 30
stations using up to four characters.

Note: Delete channel captions by entenng spaces

sn all four character slots.

-4-