Pace TP-100 Service Manual

Operation MANUAL FOR THE TP-100

P/N 5050-0568 Revision A

Tip Cartridge Installation

TP-100 Tip Cartridges are fitted with a key lock device. This feature ensures that tip cartridges are held firml in position and will maintain their orientation. To install a tip cartridge, please follow the procedure below.

Line up the key lock feature on the tip cartridge with the notch on the front of the handpiece.

Notch

Key Loc

fter partially inserting tip, align vacuum tupe with

hole in tip.

Push the tip cartridge all the way into the handpiece.

acuum tube will extend approximately .2" beyond

end of tip.

Insert suction cup onto end of vacuum tube.

Connect the handpiece connector plug into the Power Receptacle in the following manner:

1. Align guide on the connector with slot on power receptacle.

2. Insert connector into power receptacle.

3. Turn the connector housing clockwise to lock in place.

Slot

Guide

Insert vacuum hose connector into base uni

Connect foot pedal to foot pedal input on the back of your system.

OPERATION:

Select the appropriate top for the component you are removing and install it in the handpiece. Allow tip to come to temperature and tin tip so there is solder covering the edges of the tip. This improves the thermal linkage between the component leads and the tip Place tip over component and the solder will melt. When the solder holding the leads to the PCB has melted (A slight twisting motion with very delicate pressure can be used to verify component reflow) Activate vacuum using foot pedal and lift component from PCB.

Replacement Parts

6010-0158-P1 Handpiece 6993-0280-P1 Handpiece kit 6008-0115-P1 Foot Pedal 1124-2001-P1 TIP, TP-100, LQFP, 12mm X 12mm 1124-2002-P1 TIP, TP-100, LQFP, 14mm X 14mm 1124-2003-P1 TIP, TP-100 ,LQFP, 20mm X 20mm 1124-2004-P1 TIP, TP-100, LQFP, 24mm X 24mm 1124-2005-P1 TIP, TP-100, LQFP, 28mm X 28mm 1124-2006-P1 TIP, TP100, QFP,14mm X 14mm X 3.2mm 1124-2007-P1 TIP, TP100, QFP, 14mm X 14mm X 3.9mm 1124-2008-P1 TIP,TP100,QFP,14mmX14mmX3.2mm 1124-2009-P1 TIP,TP100,QFP,14mmX20mmX3.9mm 1124-2010-P1 TIPTP100QFP28mmX28mmX2.6/3.2mm 1124-2011-P1 TIPTP-100,QFP28mmX28mmX3.9mm 1121-0382-P2 VACUUM CUP S.D.,.195DIA 1121-0383-P2 VACUUM CUP S.D.,.300DIA 1121-0384-P2 VACUUM CUP S.D.,.500DIA 6993-0153-P1 Vacuum Cup Kit - one of each size 1100-0307-P1 Hot Grip Removal Pad 1100-0239-P1 Tip Tool 6019-0069-P1 Tool Stand for TD-100 1259-0102-P1 Vacuum Hose Connector