Pace VPN-Lite, Telkom 921VNX User Manual

Telkom VPN-Lite router setup

User Manual

Pace 921VNX

TELKOM VPN-Lite 2.5 ver.100712 Page 2

Contents

Introduction......................................................................................................................................................... 3

Before you start .................................................................................................................................................. 4

VPN-Lite Setup using the Web Browser Wizard ............................................................................................. 5

VPN-Lite Manual Setup Using Telnet ............................................................................................................... 7

Firmware Upgrade ............................................................................................................................................ 13

TELKOM VPN-Lite 2.5 ver.100712 Page 3

Introduction

Welcome to the Telkom VPN Lite router setup user manual. This manual will provide information on
how to setup the Telkom VPN Lite service on your Pace 921VNX using the setup utility, the router’s
graphical user interface (GUI) and CLI (Telnet or Console connection) commands (advanced user
only).

o To ensure that the utility works correctly please temporarily

disabled all software firewall applications. These
applications may interfere with the processes needed to
successfully complete the router setup. Examples of these
applications/programs include: Norton Anti-virus, PC-Cillin,
Bit Defender and McAfee.

TELKOM VPN-Lite 2.5 ver.100712 Page 4

Before you start

Register VPN-Lite service.

To enable you to configure the Telkom VPN-Lite service on your Pace Router you first need to
register for the VPN-Lite service on the Telkom website (www.telkom.co.za).

On the VPN-Lite registration site you will be able to configure and manage your VPN-Lite sites as
shown in the image below.

Here you will retrieve vital information like site Usernames and LAN Subnets and Site Password to
configure the VPN-Lite sites. In the below setup sections you will be required to enter these values.
Please ensure that you have all the correct information for each site before you start any of the setup
sections mentioned in this document. Below is an image to show you what information on the VPN­Lite setup site needs to be retrieved to enable you to setup you VPN-Lite. You can find this screen in
the Manage Sites section.

o This manual assumes that the Pace 921VNX is in its

factory default state. Thus:

LAN IP = 10.0.0.2

o It is recommended to use the utility to setup VPN-Lite

on your Pace 921VNX. The routers graphical user
interface or manual setup method is to be used by
experienced users only.

o Please ensure that your PC is set to obtain an IP

address automatically from the router’s DHCP server.

TELKOM VPN-Lite 2.5 ver.100712 Page 5

VPN-Lite Setup using the Web Browser Wizard

This section will guide you through the relative steps to setup you VPN-Lite service using the router’s
built-in VPN-Lite Wizard in the web browser.

Connection to the router using your web browser

Open a web browser like Internet Explorer or Mozilla Firefox. In the internet address bar type in
http://10.0.0.2 and press enter. You will be prompted to supply a username and password. The default
user name is admin and the password is admin.

Setup your VPN-Lite

After the router’s graphical user interface was successfully loaded in your web browser, firstly click on
Router and then select VPN Lite, in the menu on the left of the screen. The following screen will
appear.