Ozito DSR-3000 Instruction Manual

DELTA
SANDER

260W

INSTRUCTION MANUAL

SPECIFICATIONS

Rated Voltage: 230 – 240V ~ 50Hz
Power: 260W
No Load Speed: 6000 – 11000/min
Pad Size: 93 x 93 x 93mm
Paper Fitment: Hook and Loop

DSR-3000

WHAT’S IN THE BOX

ozito.com.au

Delta Sander

Dust Extraction
Adaptor

Sanding Paper x 3

3

ONLINE MANUAL

Scan this QR Code with your
mobile device to take you to
the online manual.

1. Front sure grip handle

2. Hook & loop sanding pad

3. Variable speed dial

4. Rear sure grip handle

5. On/Off switch

6. Dust extraction port

DELTA SANDER

ACCESSORIES

KNOW YOUR PRODUCT

1. HOOK & LOOP SANDING SHEET

SETUP & PREPARATION

Ensure the tool is disconnected from the power supply
before performing any of the following operations.

2. To remove, peel the sanding
sheet off sanding pad from
one corner.

3. Replace hook & loop
sanding pad when worn (see
maintenance section).

1. When placing the sheet, align the holes on the sanding sheet with

the holes on the sanding pad. Press rmly to secure.

7. Sanding sheets x 3

8. Dust extraction adaptor

3. CONTROLS2. DuST ExTRACTION ADAPTOR

OPERATION

WARNING! THE DUST THAT IS PRODUCED WHILE

WORKING CAN BE DETRIMENTAL TO HEALTH,
INFLAMMABLE OR EXPLOSIVE. SUITABLE SAFETY
MEASURES ARE REQUIRED. USE SUITABLE DUST
EXTRACTION AND WEAR A DUST RESPIRATOR.

1. Slide the dust extraction adaptor into the dust extraction port.

2. Connect a dust
extraction hose to
the dust extraction
adaptor.

3. Run the dust extraction
device while operating the
delta sander.

On/ Off Switch

To turn on, push the ON/OFF
switch forward to “I” position.

To turn off, push the ON/OFF
switch backward to “0” position.

Variable Speed

The tool is recommended for use with a residual current
device with a rated residual current of 30mA or less.

1. Turn the delta sander on.

2. Scroll through variable
speed dial to select desired
speed setting.

Note: The higher the number on the variable speed dial,
the faster the oscilation frequency of the delta sander.

Low

High