Ozito DMC-1000 Instruction Manual
B
A
R
P
S
I
DIGITAL MINI
COMPRESSOR
12V
INSTRUCTION MANUAL
SPECIFICATIONS
Voltage: 12V
Max Current: 10Amp
Max Pressure: 100psi
Flow Rate: 16 l/min
Weight: 1kg
DMC-1000
WHAT’S IN THE BOX
ozito.com.au
Digital Compressor
Accessories x 7
B
A
R
P
S
I
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
B
A
R
P
S
I
1 LED Light
2 Light Button
3 PSI / BAR Button
4 Digital Pressure Gauge
5 Carry Handle
6 On/Off Button
7 Side Compartment
8 Air Hose
9 12V Socket
10 High Volume Hose
11 Adaptor Storage
12 High Volume Air Outlet
FRONT VIEW
BACK / BASE VIEW
ACCESSORIES
KNOW YOUR PRODUCT
1. ADAPTORS
SETUP & PREPARATION
13 High Pressure Adaptor
14 Medium Adaptor
15 Large Adaptor
16 General Purpose Adaptors
17 Ball Adaptor
Removing Adaptors
Side Compartment
Base Compartment
1 To open the side compartment,
slide the door up. Lower the
door to expose the adaptors.
1 Turn the unit over so you can
see the base.
2 Remove the
required adaptor.
2 The 3 adaptors and
air hose can now be
removed.
3 To close the side compartment
raise the door and slide down
to secure.
The compressor unit has 7 adaptors to allow a range of functions. All
the adaptors are secured in either the compartment on the side or
base.
WARNING: ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING STEPS.
1 2 3 4 5
6 7
8 9 10
11
12
13
14
15
16
17
3. CONTROLS
Light Button
PSI / BAR Button
1 To turn the LED light on, press
the light button in.
1 To switch between the two
pressure units, press the PSI /
BAR button.
2 To turn the LED light off, press
the light button again.
Note: The compressor must be connected to the power for the LED
light to work.
The compressor has a built-in LED light for ease of use at night or in a
dark area.
The digital pressure reading can be switch between PSI and BAR to
match the requirements on the item being inated.
To identify the current pressure units, a light will be illuminated on the
right side of the digital display.
B
A
R
P
S
I
B
A
R
P
S
I
B
A
R
P
S
I
2. SWITCHING ON & OFF
Connecting to a 12V outlet
Switching On and Off
1 Roll out the 12V socket from
the base of the unit.
1 To start the air compressor
press down the on/off button
with your foot.
The compressor is tted with a foot peddel on/off button to allow ease
of use while holding adaptors and the item being inated.
2 Connect the 12V
socket to 12V DC
outlet which can be
found in your vehicle.
Check car outlet for
sufcent power up to
120W.
2 Release the on/off
button to stop the
compressor.
B
A
R
P
S
I
WARNING:COMPRESSED AIR CAN BE DANGEROUS.
NEVER POINT THE OUTLET NOZZLE TOWARDS ANY
PART OF YOUR BODY OR ANOTHER PERSON.
OPERATION
Loading...