Outform UID0004 Users Manual

i View Touch

User Manual

UnRegistered

UnRegistered

Index

12

12

13

Video

16

17

18

24

25

26

26

3

Quick Start
Flash

13
14

17

Picture
Buttons and Remote Control
Screen Status Indicators
Menu Features
Playlist
Wi-Fi
Calander
Settings
Power Supply Unit Electrical Data
LCD Screen Specification

UnRegistered

Safety and Warnings

Main Supply

This equipment is designed to operate from a 100-240 Volt, 50/60Hz AC main

Main Unit

which countries where the product may be used freely:

Netherlands,

Norway and Iceland.France:

Main Adaptor

which can be determined by turning the equipment off and on, the user is

Increase the separation between the equipment and receiver.

supply. The use of other power sources may damage this equipment. Check
that the voltage marked on the rating plate located at the rear of the power
adaptor states 100-240V. The manufacturer will NOT accept responsibility for
damage or injury caused by connecting to the wrong voltage.

This device complies with CE/FCC regulations. The device has been evaluated to meet general RF
exposure requirement. The device can be used inportable exposure condition without restriction.CE in

Germany, UK, Italy, Spain, Belgium,
Portugal, Greece, Ireland, Denmark, Luxembourg,Austria, Finland, Sweden,
except the channel 10 through 13, law prohibits the use of other channels.

The power adaptor supplied is compatible with a standard main socket. NB. If
the power adaptor or lead gets damaged, it must be replaced by a qualified
service agent with an approved adaptor of the same type and rating.

Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) This device must accept any interference
received, including interference which may cause undesired operation. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interfer¬ence to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,

encour¬aged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.

UnRegistered

4

Main Supply / Main Adaptor

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

ment

well as leave within 20cm between the radiator & your body.

Warning

with liquids on or near the product.

the network controller via the SDIO interface or the second USB OTG interface.

Consult the dealer or an experienced radio / TV technician for help. In
accordance with FCC requirements, changes or modifications not expressly
approved by manufacturer could void the user’s authority to operate this
product.

FCC Radiation Exposure State

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be leave 20cm outside as

Dangerous voltage constituting a risk of electric shock is present
inside this equipment.

This mark is applied to show the equipment conforms to European
safety and electro-magnetic compatibility standards.

There are important operating and maintenance instructions in the
literature accompanying this equipment.

The main plug shall be the main disconnect device and shall remain operable at
all times.
Never let anyone push objects into holes and ventilation slots. Do not
expose this product to dripping or splashing or place any objects filled

Do not place a naked flame source such as lighted candles on or near this
product. Do not attempt to repair this product yourself; always get a qualified
service agent to carry out adjustments or repairs.
WLAN of units is been restriction in the horizontal. AML8626-H supports WiFi
connection via external WiFi module or dongle. The AML8626-H interfaces to

The AVOS operating system provides the complete networking environment
and applications。

UnRegistered

FCC Radiation Exposure Statement / Warning

5

6

UnRegistered

Overview

Components

i View Touch unit

Power Supply Unit - US, EU, UK Plugs
available Remote Control
4 Cell Rechargeable Battery - Not included in the
package. (Must be purchased separately) Desk Mount
Clip (not seen in picture) - Not included in the package..
(Must be purchased separately) Securing Cable (not
seen in picture) - Not included in the package.. (Must be
purchased separately) Landscape/Portrait positioning

screwdriver Landscape/Portrait
positioning screw User Manual

UnRegistered

Components / Front View

7

Side A

Setting buttons

Left In menu mode, this function is used for moving left through the various

options. In playback mode you can go to the previous content in the playlist.

In playback mode, it is

OK

In playback mode:

een

ns.

Used to return to the main menu (first menu page).

Side B

Silicon cover for slots

This reduces access to slots or prevents stealing of

SD Card (if used). To insert or remove an SD Card

(Note: it is only operational for content copied from USB or SD Card, not for
content downloaded from i-Display Content Management System).

Right In menu mode, this function is used for moving right through the various
options. In playback mode you can go to the next content in the playlist. (Note:
it is only operational for content copied from USB or SD Card, not for content
downloaded from i-Display Content Management System).

Up In menu mode, this button is used for moving left.
used to increase the volume if current content being played is a movie.

Down In menu mode, this button is used for moving right. In playback mode, it
is used to decrease the volume if current content being played is a movie.

Misc In menu mode, this function is used for the same function as the
OSD button on the remote control (as explained in Remote Control
section). In playback mode, it is not operational.

Short press - Used for making changes betw
(i)
(ii)

Long Press (3 seconds) - Used to return to the menu
page. In menu mode:

Short press - Used for selecting various optio
Long press (3 seconds) -

Repeat selected movie (repeats the chosen file in endless loop).
Repeat all (repeats the entire playlist in endless loop).

the Silicon cover needs to be positioned as shown
and can be easily opened by gently lifting up and
turning clockwise. A screw can be added for extra
security.

UnRegistered

8

Side A / Sidw B

USB slot

This is usedfor connecting flash drives. Once the flash drive is connected, all its

SD card slot

start to play.

Important: SDCard isnot included, it must be purchased separately.

Back

DC connector

connect the power.

On/Off

Located on the back bottom section of t.

o

content is automatically copied to the internal memory. To delete old content see
Playlist section.

Once an SDCard is inserted into the unit, the content ohte SD Card will
In menu mode, the user will be able to either play content directly from the
he unit’s internal memory.

Located at theback of the unit’s leg. Used to

button

theitun
i d

onitche
d
Important: It takes approx 10 seconds for the first image to
appear once the unit is

Red button indicates the unit is

off. Green button indicates the unit is switched

UnRegistered

Back

9