Omega Echo Operation Manual & Installation Manual
10/02 MO/I_Echo
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the Company), are
warranted to be free from defects in materials and workmanship under normal use. If a product sold by the
Company proves to be defective, the Company will repair or replace it free of charge within the first year and
thereafter all parts to be repaired will be free with only a nominal charge for Omega Research and Development,
Inc.'s labor and return shipping, to the original owner during the lifetime of the car in which it was originally
installed.
All products for warranty repair must be sent postage prepaid to Omega Research & Development, Inc.,
P.O. Box 508, Douglasville, Georgia 30133, with bill of sale or other dated proof of purchase. This warranty is
nontransferable and does not apply to any product damaged by accident, physical or electrical misuse or abuse,
improper installation, alteration, any use contrary to its intended function, unauthorized service, fire, flood,
lightning, or other acts of God.
This warranty limits the Company's liability to the repair or replacement of the product. The Company shall
not be responsible for removal and/or reinstallation charges, damage to or theft of the vehicle or its contents, or
any incidental or consequential damages caused by any failure or alleged failure of the product to function
properly. Under No Circumstances Should This Warranty, Or The Product Covered By It, Be Construed As A
Guarantee Or Insurance Policy Against Loss. The Company neither assumes nor authorizes any person or
organization to make any Warranties or assume any liability in connection with the sale, installation, or use of
this product.
L I M I T E D L I F E T I M E W A R R A N T Y
This device complies with FCC Rules part 15. Operation is subject to the following two conditions, (1) This
device may not cause harmful interference and, (2) This device must accept any interference that may be
received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment. Such modifications could void the user's authority to operate the equipment.
COPYRIGHT 2002: OMEGA RESEARCH & DEVELOPMENT, INC.
Omega
Echo
OPERATION GUIDE &
INSTALLATION MANUAL
2-Way Controller Transceiver
FRONT COVER
PRINTER’S NOTE:
production front cover
is gray scale; this is a
place marker cover.
BACK COVER
PRINTER’S NOTE:
production back cover
is to be printed with gray
scale front cover; this is a
place marker cover.
THE OMEGA ECHO 2-WAY TRANSCEIVER
“Arm/Lock”
Button
“Disarm/Unlock”
Button
“III”
Button
“II”
Button
Programming
Button
On the rear side is battery compartment. The Echo uses a standard
“AAA” 1.5 volt battery, and it will indicate when to replace the battery.
LCD
Screen
INSTALLING THE ECHO TRANSCEIVER SYSTEM
The Omega Echo transmits to and receives its signal from a remotely-mounted base receiver/transmitter unit which is plugged directly into the host security system module; no
other wiring connections are needed. The base receiver/transmitter unit may be mounted
directly to an interior glass by utilizing the attached adhesive pad (clean and prepare the
glass before adhering) for the best operating range. If a hidden location is desired, the base
transmitter/receiver unit should be placed as high as possible in the vehicle, avoiding metal
parts and wiring harnesses.
Original
Security
System
Receiver
Echo Base
Transmitter/
Receiver Unit
Step 1 Remove the
security system’s original
receiver unit and its wiring
harness.
Step 2 Replace the original receiver with
the Echo transmitter/receiver unit and
wiring harness. Using the adhesive tape,
mount the Echo transmitter/receiver onto
an interior glass
(carefully clean the surface).
Host Omega Security
System Control
Module
Plug into the Receiver /
Transceiver
Port
ECHO ) ) )
( ( ( Omega
Step 3 Program the Echo transceiver and the
original 1-way transmitters into the security system.
Loading...