AWD Lock Switch (if so equipped) ......................12
Vehicle Dynamic Control (VDC) OFF Switch ................12
Front Passenger Air Bag Status Light ....................12
Tire Pressure Monitoring System (TPMS) ..................13
Child Safety Rear Door Lock .........................13
Seat Belt Warning Light and Chime .....................13
Moonroof Controls (if so equipped) .....................14
Front Seat Adjustments ............................14
Folding the Front Passenger Seat Down (if so equipped) .........15
Folding the Rear Seatback Down .......................15
HomeLink姞 Universal Transceiver (if so equipped) .............15
TABLE OF CONTENTS
Bluetooth姞 Hands-Free Phone System (if so equipped)..........17
TM
(if so equipped) ..................2
This easy-to-use Quick Reference Guide is intended to help you more fully
appreciate some of the unique features and functions of your new vehicle.
However, it is not intended to replace your Owner’s Manual. The Owner’s
Manual contains more detailed information to help you better understand the
important safety warnings, features, operation and maintenance of your
vehicle. All information, specifications, photographs and illustrations in this
publication are those in effect at the time of printing. NISSAN reserves the
right to change specifications or design without notice and without
obligation.
REMOTE KEYLESS ENTRY SYSTEM (if so equipped)
LOCK DOORS
Press the
UNLOCK DOORS
Press the
only. Press the button again within 5 seconds to unlock
all doors.
USING THE PANIC ALARM
Press and hold the
onds. The panic alarm will sound and the headlights will
stay on for 25 seconds. The panic alarm stops when it
has run for 25 seconds or when any button is pressed on the keyfob.
button to lock all doors.
button once to unlock the driver’s door
button for longer than 0.5 sec-
SILENCING THE HORN BEEP FEATURE
䡲 To deactivate: Press and hold theandbuttons for at least 2 seconds.
䡲 To activate: Press and hold the
andbuttons for at least 2 seconds.
NISSAN INTELLIGENT KEYTM(if so equipped)
The NISSAN Intelligent KeyTMallows you to lock or unlock your
vehicle and start the engine.
NOTE: It is important to make sure the Intelligent Key is with you
(that is, in your pocket or purse).
䡲 The operating range of the door lock/unlock function is
approximately 31.50 in (80 cm).
䡲 Locking the vehicle - Push any door handle Request
Switch
䡲 Unlocking the vehicle - Push any door handle Request
Switch
the door handle Request Switch
all other doors will unlock.
once.
once. The corresponding door will unlock. Push
again within 1 minute;
2
STARTING THE ENGINE
䡲 Push the ignition knob in.
䡲 Confirm the Intelligent Key system warning light is illuminated
green.
䡲 Turn the ignition knob to the START position to start the
engine.
TURNING THE ENGINE OFF
䡲 Shift the transmission into P (Park).
䡲 Turn the ignition knob to the LOCK position.
䡲 An audible warning chime will sound when exiting the vehicle if the ignition knob is not
completely turned to the OFF position.
AUTOMATIC DOOR LOCKS
䡲 All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
䡲 All doors unlock automatically when the ignition is placed in the OFF position (Intelligent
Key equipped vehicles) or when the key is removed from the ignition switch (mechanical
key equipped vehicles).
The automatic lock and unlock functions can be deactivated or activated independently of each other. To deactivate or activate the automatic door lock or unlock
system, perform the following procedure:
1. Close all doors.
2. Place the ignition switch in the ON position.
3. Do one of the following within 20 seconds of performing Step #2:
● To change AUTO UNLOCK settings: push and hold the power door lock switch to
position (UNLOCK) for more than 5 seconds.
the
● To change AUTO LOCK settings: push and hold the power door lock switch to
the
position (LOCK) for more than 5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard
indicator will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each
setting change.
3
WINDSHIELD WIPER/WASHER SWITCH
䡲 The ignition switch must be in the ON position to
activate the windshield wipers.
䡲 Move the lever to the following positions to oper-
ate the windshield wipers:
Intermittent (INT) – Front wipers operate
intermittently and can be further adjusted by
twisting the time control ring
Low Speed (LO) – Continuous low-speed
operation of front wipers.
High Speed (HI) – Continuous high-speed
operation of front wipers.
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
Rear Wipers (REAR) – Twist the end section to operate the first (INT) or second
(ON) speed settings for the rear wipers.
䡲 The washer function activates the washer fluid and several sweeps of the wipers:
● For FRONT WASHER, pull lever toward you.
● For REAR WIPER, push lever away from you.
.
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT CONTROL SWITCH
䡲 Turn the headlight control switchto the
position to turn on the front parking, tail, license plate
and instrument panel lights.
䡲 Turn the headlight control switch
sition to turn on the headlights. All other lights remain
on.
to thepo-
FOG LIGHT OPERATION
NOTE: The headlights must be on and the low beams selected for the fog lights to operate.
䡲 Turn the switch (inside collar)
䡲 Turn the switch (inside collar)
4
to theposition to turn on the fog lights.
to the OFF position to turn off the fog lights.
HIGH BEAM
䡲 Push the headlight control switch forwardto
select the high beam function. The blue
cator light illuminates. Pull the headlight switch
back to the original position to select the low beam.
The blue
䡲 Pull and release the headlight control switch
to flash the headlight high beams on and off.
indicator light goes off.
indi-
HEADLIGHT AIMING CONTROL SWITCH (if so equipped)
Depending on the number of occupants in the vehicle and the load it is
carrying, the headlights may be aimed higher than desired. If the vehicle
is traveling on a hilly road, the headlights may directly hit the rearview
mirror of the vehicle ahead or the windshield of the oncoming vehicle.
The light axis can be lowered with the operation of the switch.
䡲 With maximum/heavy loads, select position 3.
䡲 When traveling without a heavy load or on a flat road, select
position 0.
STEERING WHEEL SWITCHES FOR AUDIO CONTROL/
BLUETOOTH姞 (if so equipped)
䡲 Press the SOURCE button to turn the audio system on.
䡲 To choose AM, FM, XM姞, CD or AUX press SOURCE
repeatedly.
䡲 The tuning up or down
the following:
● Push the
change the radio frequency.
● Push and hold the
onds to seek the next or previous broadcasting radio
station.
● Push the
the CD.
● If the vehicle is equipped with a CD changer, push and hold the
than 1.5 seconds to change between CDs.
䡲 Push the + or – control switch to increase or decrease the volume.
switch for less than 1.5 seconds to
switch while playing a CD for less than 1.5 seconds to change tracks on
switch can be used to perform
switch for more than 1.5 sec-
switch for more
5
CRUISE CONTROL
䡲 To activate the cruise control, push the ON·OFF
switch. The indicator light in the instrument panel
will illuminate.
䡲 To set cruising speed, accelerate the vehicle to
the desired speed, push the COAST/SET switch
and release it. The SET indicator light in the
instrument panel will illuminate.
䡲 To reset at a faster cruising speed, push and hold
the ACCEL/RES switch. When the vehicle attains the speed you desire, release the switch.
䡲 To reset at a slower cruising speed, push and hold the COAST/SET switch. Release
the switch when the vehicle slows to the desired speed.
䡲 To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET
indicator light in the instrument panel will go out.
䡲 To resume a preset speed, push and release the ACCEL/RES switch. The vehicle
returns to the last set cruising speed when the vehicle speed is over 24 MPH (38 km/h).
䡲 To turn off cruise control, push the ON·OFF switch. Both the CRUISE indicator light and
the SET indicator light in the instrument panel will go out.
MANUAL CLIMATE CONTROL
FAN SPEED CONTROL DIAL
Turn the fan speed control dial
TEMPERATURE CONTROL DIAL
Turn the temperature control dial for the desired temperature. Turnthe control dial to the
left for cold air or right for hot air.
6
to the left (slow) or right (fast) to control fan speed.
AIR FLOW CONTROL DIAL
Turn the dial to select the following air flow outlets:
Air flows from center and side vents with maximum cooling (air conditioning).
Air flows from the center and side vents.
Air flows from the center, side, and foot vents.
Air flows mainly from the foot vent.
Air flows from the defroster and foot vents.
Air flows mainly from the defroster vents.
DEFROSTING/DEFOGGING FRONT AND SIDE WINDOWS
䡲 Turn the air flow control dial to the front window defroster mode
. The A/C
automatically turns on when the defroster mode is selected.
䡲 Turn the temperature control dial left or right to set the desired temperature.
䡲 To set the defroster on high, turn both the fan speed dial
control
all the way to the right.
and the temperature
DEFROSTING/DEFOGGING REAR WINDOW
Push the rear window defroster switch
on. Push the switch again to manually turn
the defroster off. This function automatically turns off in approximately 15 minutes.
A/C ON/OFF BUTTON
Press the A/C button on the instrument panel to manually turn the A/C on or off.
AIR RECIRCULATION BUTTON
䡲 Press the air recirculation button
䡲 Press the air recirculation button
to recirculate air inside the vehicle.
again to turn air recirculation off.
䡲 The air recirculation mode is only functional when the air flow control dial is in the
following positions:
and.
7
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.