Nikon COOLPIX 5000 update Manual

Nikon Firmware Update for Coolpix 5000 Version 1.6

Notes:

1. It is most important that you follow the supplied directions; failure to follow
all of the steps may result in your camera being disabled.

2. This update is for Coolpix 5000 cameras only! It is strongly suggested that
you avoid any background process that may disrupt the Updater
communication process.

3. It is advised not to touch the mouse or keyboard once the uploader starts
to ensure against accidental launch of an application or other process.

4. This Software and Firmware is Licensed and Copyright of Nikon
Corporation Japan

1.0 System requirements

Macintosh users:

Mac® OS 9.0.4
Mac® OS 9.1.x
Mac® OS 9.2.x

Mac® OS X is NOT supported

2.0 About software and firmware

The “Firmware Uploader Software for the E5000 Ver.1.6” is a computer
program that updates the firmware in your COOLPIX 5000 (E-5000). The
firmware is a program, which runs inside the camera and controls its
operation. By running the Uploader Software you will install the new firmware
in the camera.

The process of transferring the new firmware from the computer to the
camera is sometimes called “Uploading,” “Upgrading” or “Updating” the
firmware.

If your camera is version 1.5 it is recommended that you update the firmware
in your camera to 1.6 in order to benefit from improved operating
performance.

The entire package (Uploader software and new firmware for the camera) is
supplied in a single file, which is compressed for distribution over the Internet.
Before performing a firmware update, you must de-compress the files back to
their original format.

3.0 Improvements and bug fixes in version 1.6

The principal changes to the camera firmware with the release of version 1.6
are in the form of the following improvements to product performance and
minor bug fixes (not listed):

1. The Coolpix 5000 lens will no longer get stuck when it moves forward
during the camera operation.

4.0 Restrictions on Usage

This utility will update the firmware in your COOLPIX 5000 to version 1.6. It
can only be used if the version of the firmware in your COOLPIX 5000 is
version 1.5 and is not suitable for use with any other model of Coolpix
camera. This version of the firmware can only update NTSC cameras.

5.0 Warnings

Your COOLPIX 5000 could malfunction should any of the problems listed
below occur while the firmware is being upgraded. Please exercise all
necessary caution during the upgrade. The upgrade can be performed for you
at a Nikon-authorized service center in the event that you do not have the
equipment necessary to perform the upgrade, or are otherwise unsure that
you would be able to perform the upgrade yourself. Your COOLPIX 5000
could malfunction should any of the following occur during upgrade:

1. The camera turns off during the upgrade process

2. The data cable is disconnected

3. A problem occurs with the computer

4. The upgrade is performed in a place where there is excessive electrical
noise.

The camera could also malfunction if you make a forced exit from the
uploader or another application interferes with the uploader during the
upgrade. Be sure to exit any other applications before running the uploader

software.

6.0 Confirming the current firmware version

1. Turn the camera off

2. Hold down the MENU button.

3. Turn the camera “On” while continuing to hold down the MENU button until
an image appears. The screen will display the current firmware version like:
“E5000V1.5”. If it reads other than 1.5, your firmware should not be
updated.

4. Turn the select dial “Off”. This completes the version confirmation
procedure.

7.0 Prepare for the Upgrade

Please make sure that you have the following items available