Nikon 1149EA, 2149EA Compliance Manual
En
English
Ck
中文版（简体）
Wireless Regulation Data
Compliance Statement
This device complies with Part 15 of the FCC Rules and
with RSS-210 of Industry Canada. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Ce dispositif est déclaré conforme à la Partie 15 de la
Réglementation FCC et à la norme RSS-210 d’Industrie
Canada. Son fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas causer d’interférences nuisi-
bles, et
(2) cet appareil doit accepter les interférences reçues, y
compris celles
susceptibles de causer un fonctionnement indésirable.
Modifi cations not expressly approved by Nikon
Corporation could void the user’s authority to operate
the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Printed in Japan
SB2E01(##)
6M######-01
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiofrequency radiation exposure information:
The radiated output power of the device is far below the
FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact during normal
operation is minimized.
Notice for Customers in Singapore
Trade Name:
Model: WR-R10
This device complies with radio-frequency regulations.
The content of certifi cation labels not affi xed to the device is given below.
Trade Name:
Model: WR-T10
Complies with
IDA Standards
DA103423
Notice for Customers in Australia and
New Zealand
This device complies with radio-frequency regulations.
The content of certifi cation labels not affi xed to the device is given below.
N16184
Notice for Customers in South Africa
This device complies with radio-frequency regulations.
The content of certifi cation labels not affi xed to the device is given below.
TA-####/####
APPROVED
无线管理规定
新加坡用户须知
商号：
型号：
WR-R10
商号：
型号：
WR-T10
本设备遵循无线电频率规定。未粘贴
至本设备的认证标签内容如下。
Complies with
IDA Standards
DA103423
Ch
繁體中文
Ar
#######
無線管理規定
台灣用戶須知
使用無線區域網路產品時的注意事項
第十二條
經型式認證合格之低功率射頻電機，非經許
可，公司、商號或使用者均不得擅自變更頻
率、加大功率或變更原設計之特性及功能。
第十四條
低功率射頻電機之使用不得影響飛航安全及干
擾合法通信；經發現有干擾現象時，應立即停
用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通
信。
低功率射頻電機須忍受合法通信或工業、科學
及醫療用電波輻射性電機設備之干擾。
本裝置遵循無線電頻率規定。未粘貼至本裝置
的認證標籤內容如下。
CCXXxxYYyyZzW
WR-R10
低功率電波輻射性電機管理辦法
第12條 經型式認證合格之低功率射頻電機，非
經許可，公司、商號或使用者均不得擅自變更
頻率、加大功率或變更原設計之特性及功能。
第
低功率射頻電機之使用不得影響飛航
14條
安全及干擾合法通信；經發現有干擾現象時，
應立即停用，並改善至無干擾時方得繼續使
用。前項合法通信，指依電信法規定作業之無
線電通信。低功率射頻電機須忍受合法通信或
工業、科學及醫療用電波輻射性電機設備之干
擾。
Wireless Regulation Data
Notice for Customers in the UAE
Trade Name:
Model: WR-R10
This device complies with radio-frequency regulations.
The content of certifi cation labels not affi xed to the device is given below.
WR-R10 WR-T10
TRA
REGISTERED No:
#########/##
DEALER No:
DA0087468/12
Trade Name:
Model: WR-T10
TRA
REGISTERED No:
#########/##
DEALER No:
DA0087468/12
CCXXxxYYyyZzW
WR-T10
Loading...